0
There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you fix a valve cover gasket leak on 02 grand vitara?
either tighten the valve cover bolts, or replace the gaskets.
What order do you tighten valve cover bolts on a 2005 5.4?
[object Object]
How do you tighten a valve cover on 2000 Camry?
Use 20 ft-pound torque.
How do you change a valve cover gasket in a 92 Honda Civic and is it difficult?
remove bolts on top of valve cover, use a putty knife or a paint scrapper to remove old gasket from valve cover and cylinder head be careful not to get anything in the head. use a type of silicone to secusre new gasket to valve cover and use only on the valve cover side. a little bit will do a few spots around it and put cover back on. tighten bolts from center out and do not over tighten. just snug them up.
How do you change valve cover gaskets in 1993 Buick Regal 3.8 engine?
Remove each valve cover (four bolts.) Remove the gasket and set a new one in place. Set the valve cover in place and tighten the bolts to spec.
How do you Change valve cover gasket Chevy s10 blazer?
you just pull the three bolts holding the valve cover down. the bolts run right down the middle of the valve covers. pull the valve cover off, replace the old gasket with the new one and tighten the valve covers back on.
How do you replace rear cam plug 193 240 Volvo?
You remove the valve cover, install a new plug & valve cover gasket, and reinstall the valve cover. The part number for the plug is 1336763. Careful not to overtighten the small valve cover bolts (6mm thread), and tighten them in alternating sequence (not in a circle, and gradually).
I have an 1981 Chevy 350 that's has a leaking valve passenger side valve cover. i replaced the gasket twice but is still leaking. any ideas bent valve cover maybe?
Probably a bent valve cover from overtightening Replace or try to straighten then tighten to 10 inch lbs. only
How to Replace valve cover gasket 2002 dodge neon?
remove the valve cover pull off the valve cover gasket and put new one up making sure you dont over tighten the valve cover bolts make sure you have correct torque replace all the o rings inside valve cover while changing main gasket for best results
What is the torque and tightening sequence for the valve cover gasket for a 1992 for tempo 4 cylinder?
Torque for valve cover bolts is 7 to 10 ft. Lbs . Tighten the bolts in a criss-cross pattern .
How tight does the bolts on a 94 Dodge Intrepid valve cover have to be?
The bolts on a 94 Dodge Intrepid valve cover need to be very tight. You should tighten to 12 N*m or 105 inch pounds.
What is the manufactured torque spec on a valve cover when tightening the bolts on 2001 FORD expedition?
Tighten the valve cover retaining bolts in sequence, torque them to 71-106 inch lbs. (8-12 Nm).
