how do you tighten fan belt on l200
just in front of the altenator, there is a 10mm bolt, tighten that and it will tighten the fan belt
theres no way to tighten it you will have to buy a new belt
first you have to locate the allready plced soket and then just tighten the belt
To tighten the fan belt on a Renault Master, a person needs to adjust the belt tension wheel. This wheel has a bolt that is inserted in a groove. The bolt can be loosened and then moved to the desired location to tighten the belt.
There is no fan belt on any year Fiero. Electric fan motor,
If it is a serpentine belt you replace the tensioner pulley
with the automatic belt tensioner..
Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.
The fan is electric, not belt driven. The serpentine belt is has a spring loaded tensioner. If the belt is loose, the tensioner has failed.
The belt has an automatic spring tensioner and can not be "tightened".
The fans are electric and do not have a belt The fans are electric and do not have a belt The fans are electric and do not have a belt
you carnt you have tu go to a shop :)
take it to a garage and get if fixed
you replace the spring tensioner or the belt because there are no adjustments.
If it is a newer corsa (built in the last 12 years or so) if guessing you mean the alternator belt because it doesn't actually have a fan belt as the fan is driven by a electric motor. To tighten the alternator belt is very easy...Just loosen the two or three bolts holding it on (do not take them right out) pull the alternator so that the belt tightens and then tighten the bolts back up. You may need someone to hold the alternator and belt tight whilst you tighten the bolts back up. If the belt still continues to squeal after you have tightened it a couple of times it means the belt needs replacing.
first u must loosen bolt on power steering belt tensioner till the belt will come off ,then loosen alternator bolts and push alternater till belt is loose enough,then take fan belt off ,install new fan belt,use crowbar on alternator to tighten fan belt,then put power steering belt back on and tighten tensioner till its at spec. then retighteh tensioner center bolt.
you open the flap and SUCK IT!
replace it or tighten it
The belt on a 2000 Ram uses a spring loaded tensioner pulley. It self tightens.
THERE IS A BELT TENSIONER BELOW AND JUST TO THE RIGHT OF THE FAN PULLEY. LOOSEN IT COMPLETELY, AND THE NEW BELT SHOULD FIT RIGHT ON. THEN TIGHTEN THE TENSIONER TO TIGHTEN THE BELT, AND YOUR DONE. GOOD LUCK, DANNY.
It would depend on what year. The newer ones are self adjusting.
There is no adjustment you can do. It has an automatic self adjusting belt tensioner. If the belt seems to loose you may need to replace the tensioner and belt.
unloosen the 3 bolts on the alternator and push down on it and the belt will come loose, take the belt off and put new belt over the pulleys and to tighten pull up on the alternator and tighten the bottom bolt first and then check the belt for tightness, when you press on the belt there should be about 1/2 inch play, when you get it set then tighten all the bolts on the alternator and your done.