Serpentine Belts
Dodge Dakota
Nissan Maxima

How do you tighten the belt on a 1996 Nissan Maxima?

141516

Top Answer
User Avatar
Wiki User
2005-10-30 05:09:35
2005-10-30 05:09:35

most cars have an adjuster pulley where you can tighten the belt and also replaceit as well.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1996 Nissan Maxima 3.0 liter V6 engine must have a timing CHAIN because the Gates website does not list a timing belt for it

User Avatar

There is no fan belt. The fan is electric.

User Avatar

A 2002 Nissan Maxima does not having a timing belt. It has a timing chain.

User Avatar

Begin by loosening the tensioner pulley on the front of your 1996 Nissan Maxima engine. Slide the tensioner pulley to the right. The old power steering belt will become loose and can be removed. Put the new power steering belt on. Tighten the power steering belt by sliding the tensioner pulley to the left.

User Avatar

There is no timing belt in a 1997 Nissan Maxima, any model

User Avatar

need a diagram for changing belts in a 97 Nissan maxima

User Avatar

Never. It does not have a belt. It has a chain.

User Avatar

where is my power steering belt located

User Avatar

As far as I know the 1997 Nissan Maxima has a chain and does not have a cam belt. Check your owner's manual or contact a Nissan dealer to be 100% sure.

User Avatar

The 3.0 litre V6 engine in a 1995 Nissan Maxima has a timing CHAIN

User Avatar

Timing chain or most of the time doesn't need servicing

User Avatar

It must be a timing CHAIN because the Gates website does not list a timing belt for the 3.0 liter V6 in a 2000 Nissan Maxima

User Avatar

Could be timing belt tensioner.

User Avatar

To install the alternator on a 1996 Nissan Maxima you will have to remove the drive belt first and then the A/C compressor. Do not remove the refrigerant lines because the compressor will only have move down about a few inches for you to get enough room to remove the alternator. The alternator will need to be taken out from the bottom.

User Avatar

According to the Gates website , the 3.0 liter V6 in a 1987 Nissan Maxima : has a timing BELT , it's an interference engine , and change the belt at 60,000 miles

User Avatar

Yes , the 3.0 liter V6 engine in a 1991 Nissan Maxima has a timing BELT ( P.S. - it is also an interference engine )

User Avatar

If it has a serpentine belt - should be automatic through the belt tensioner

User Avatar

The serpentine belt has an easy adjustment. Loosen the nut holding the tensioner wheel and turn the adjusting screw until proper belt tension is achieved. Tighten tensioner wheel nut.

User Avatar

if its a single overhead cam it has a belt and if its dual it has a chain

User Avatar

It has a timing chain which if different--it does not need replacing at 100K like a belt!

User Avatar

Your 2000 Nissan Maxima 3.0 liter V6 has a timing CHAIN(s)

User Avatar

Nissan Maximas use a timing belt instead of a chain. Change the belts at proper intervals to prevent a vehicle breakdown.

User Avatar

There is a tensioner bolt that is connected to the alternator. You have to screw in the bolt, which will pull the alternator out and tighten the belt.

User Avatar

from underneath the car belt has to be tightened from underneath the car


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.