answersLogoWhite

0


Best Answer

You cannot tighten the belt. It has a tensioner that holds the proper tension. If the belt is loose then either the belt is worn out or the tensioner has failed.

User Avatar

Wiki User

โˆ™ 2015-07-15 19:50:38
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you tighten the serpentine belt on a 1991 Plymouth Voyager?
Write your answer...
Submit
Related questions

How to repair the hatch latch on a 1991 Plymouth voyager?

actually I broke the hood release latch on my 1991 Plymouth voyager, and I can't get the hood open, what can I do?


What type of transmission fluid for a 1991 Plymouth Voyager?

A 1991 Chrysler Voyager can use ATF+3 or ATF +4.


Where is the Crank sensor on 1991 Plymouth Voyager?

there isn't one


Where is the flasher located on a 1991 Plymouth Voyager?

The flashed in a 1991 Plymouth voyager, is generally located in the driver's seat. They would normally drive round wearing a large over coat, and flash his penis at passers by.


How many quarts of transmission fluid in a 1991 Plymouth voyager?

8 qurts


Can you use mopar atf 4 in my 1991 Plymouth grand voyager?

Yes


Where is the fuel safety solenoid located in a 1991 Plymouth voyager?

i do not believe there is a thing on this vehicle


What does a code 13 mean on a 1991 Plymouth Voyager?

No vacuum change at the MAP sensor.


Can you bypass the tension pulley on 3.3 engine for 1991 Plymouth voyager?

No I don't think so.


Where is the transmission mount located on a 1991 Plymouth voyager?

Its located on the side of the transmission, real simple to replace.


What is the torque sequence for the head on a 1991 Plymouth Voyager with a 2.5L V4?

I believe its 40 ft lbs


What is the wiring color diagram of a 1991 Plymouth Grand Voyager?

You can find wiring diagrams for this vehicle at www.autozone.com.


What type of trans fluid goes into a 1991 Plymouth Voyager?

Mopar ATF+3 or Mopar ATF+4


Where is the Plymouth Voyager oil pressure switch?

In a 1991 3.3l the oil pressure switch is located beside the oil filter


How do you remove the back seats on a 1991 Plymouth Voyager?

When you want drop a lot of heavy loads and need to pull it out, just yank it out.


Will a 1991 Plymouth Voyager 3rd row bench fit into a 2002 Chrysler Town and Country LXI?

No, the attachments are of a different shape and spacing


Tools needed toinstall front brake pads on 1991 Plymouth voyager van?

you will need a c-clamp and screwdriver and ratchett set.


Where is the speedometer sensor in a 1991 Plymouth voyager and how do i replace it?

It is in the axle shaft housing on the right side of the transmission. It is held in with one 10mm headed bolt.


How to tighten a serpentine belt on a 1991 Jeep Grand Cherokee Laredo 4.0?

Loosen up the power steering pump and pull on pump till belt is tight.


How do you take gas out of 1991 Plymouth voyager all wheel drive?

Legal: Frop the tank. Not legal: Punch a hole in the tank. Don't make any sparks!


Where is the main power distribution box 1991 Plymouth voyager?

Ours is next to the fuse box, underneath the paneling. You have to unscrew and remove the whole panel to even see it.


How do you replace a serpentine belt in a 1991 Chevy truck?

How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?


Release tension on 1991 C1500 serpentine belt?

how to release serpentine belt tensioner on 1991 C1500 Chevy Silverado?


Does the 1991 Plymouth acclaim have an interference engine?

No. A 1991 Plymouth Acclaim does not have an interference engine.


When was Voyager - film - created?

Voyager - film - was created on 1991-03-21.