answersLogoWhite

0


Best Answer

I went through the same problem. Finally went back through and reconnected my ground wire again to a different spot. Great spark, problem solved. Worth a shot. (and its free)

User Avatar

Wiki User

โˆ™ 2006-07-26 21:12:56
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you trouble shoot the ignition spark on a 1985 Honda 250ES trike All electrical parts and wiring harness have already been replaced?
Write your answer...
Submit
Related questions

Why does your 1994 Ford Taurus not start or click or anything replaced battery starter ignition switch?

Maybe you have a problem in your main wiring harness. No fun.. Could also be an electrical sensor.


Where does the oxygen sensor plug in?

It screws into the exhaust and plugs into the electrical harness.It screws into the exhaust and plugs into the electrical harness.


96 sunfire will not fire had ignition module checked its good replaced crank sensor still not firing?

check the wire harness that connects to the engine block, on the back


How do you replace the ignition switch on a 1984 Mercedes Benz 300D?

The ignition switch on a 1984 Mercedes Benz 300D is replaced by removing the lower steering column cover and disconnecting the wiring harness. The switch can then be unbolted and a new unit put in place.


Remove ignition core from 1995 ford e150 van?

Remove the ignition retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition.


Are you having electrical problems with Isuzu npr?

Truck will crank sometimes but will always turnover , done replaced disturber and cap , coil pack , and ignition wire harness, but u can roll off truck and will crank


How do you change the ignition on a 2003 cavalier?

Remove the retaining ring from the ignition switch. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition. Reverse the process to install the new ignition.


How does the ignition cylinder come out on your 91 Buick century?

Remove the ignition cylinder retaining ring. Poll the ignition cylinder out. Remove the wiring harness from the back of the ignition cylinder.


Spark plug location on 1996 Volvo 960?

They are under the cover on the top of the engine. The one that says 24 valve. Each spark plug has its own ignition coil. Be careful when unplugging the electrical harness from these coils, as the harness is known for becoming brittle and having connection issues.


How do you change ignition on 1980 kawasaki ltd 750?

Remove the retaining ring, from the ignition. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition.


How do you install an ignition switch on a 1986 Chevrolet caprice?

Attach the wiring harness to the and of your 1986 Chevrolet Caprice ignition switch. Slide the ignition switch into the ignition slot. Tighten the ignition switch with the retaining ring.


How do you replace ignition switch in 94 Chevy Suburban?

Remove the ignition switch retaining nut. Pull the ignition out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition.


What colors are in the ignition harness on a 96 Camry?

The 1996 Toyota Camry ignition harness has three wires. The red wire is the hot wire. The black wire is the ground wire. The white wire is the auxiliary wire.


How do you get ignition cylinder out on 1999 mystique?

You can change the ignition cylinder on your 1999 Mercury Mystique by removing the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out. Remove the wiring harness.


How do you remove an ignition switch on a Mercedes c220?

Remove the retaining ring at the top of your Mercedes-Benz ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.


How do you replace glow plug harness on 2000 7.3 powerstroke?

You will need to remove both valve covers and electrical connectors from the valve cover gasket, fuel injectors, and glow plugs. It's one entire harness per side and is replaced as an assembly. Good luck.


How do you replace ignition switch on a 2000 silverado?

Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.


How do you replace the ignition wiring harness and ignition switch?

you pull out the radio and dash cluster and you will have full access to the ignition just turn it over and un clip the wires


What are the car stereo wiring color codes for a 1995 Saturn SL 4 door?

I purchased this info but it didn't do me any good. I hope it's better for you.1995 SATURN SL1 4DR SEDAN Security Battery RED/WHT + (+) IGNITION SWITCH HARNESS Ignition PNK (+) IGNITION SWITCH HARNESS Starter01 YEL + (+) IGNITION SWITCH HARNESS AllDoorTrigger WHT (-) (-) BEHIND FUSEBOX UNDER CONSOLE TrunkTrigger LT.GRN (-) AT TRUNK LIGHT HoodTrigger N/A FactoryAlarmDisarm N/A ParkingLights BRN (+) AT STEERING COLUMN OR BEHIND FUSEBOX Remote Start Battery RED/WHT + (+) IGNITION SWITCH HARNESS Ignition PNK (+) IGNITION SWITCH HARNESS Ignition02 + IGNITION SWITCH HARNESS Ignition03 + Accessory01 ORG + (+) IGNITION SWITCH HARNESS Accessory02 + Starter01 YEL + (+) IGNITION SWITCH HARNESS AntiTheftSystem NONE KeySense LT.GRN (-) STEERING COLUMN HARNESS Tach WHT (-) (-) OR VIO/WHT (-) AT COIL OR MULTI COIL PAC SpeedSense DK.GRN/WHT (AC) DRIV KICK BELOW PCM 5000 PULSES ParkingLights BRN (+) AT STEERING COLUMN OR BEHIND FUSEBOX BrakeLights LT.BLU (+) AT BRAKE SWITCH ReverseLights LT GRN (+) (+) SWITCH AT PASS REAR TRANSMISSION Horn BLK (-) AT STEERING COLUMN Doorlocks / Window PowerUnLock BLK (-) (-) NEGATIVE TRIGGER PowerLock LT.BLU (-) (-) BEHIND FUSEBOX UNDER CONSOLE OR DRV KICK LeftFrontWindow01 LF:DK.BLU RightFrontWindow01 RF:DK/BLU/WHT LR:DK.GRN RR:LT.GRN LeftRearWindow01 LF:BRN RightRearWindow01 RF:TAN LR:VIO RR:VIO/WHT Convenience HeadLights TAN (+) AT LIGHT SWITCH Mobile Audio / Video Battery RED/WHT + (+) IGNITION SWITCH HARNESS Accessory01 ORG + (+) IGNITION SWITCH HARNESS Ground BLK - (-) RADIO HARNESS Illumination GRY (+) RADIO HARNESS Dimmer BRN (+) RADIO HARNESS FrontLeftSpeakerPos TAN FrontLeftSpeakerNeg GRY FrontRightSpeakerPos LT.GRN FrontRightSpeakerNeg DARK GREEN RearLeftSpeakerPos BRN RearLeftSpeakerNeg YEL RearRightSpeakerPos DK.BLU RearRightSpeakerNeg LT.BLU


Where can you find a ignition wire harness for 2005 Toyota Solara?

Your best source is a Toyota dealership. A possible alternative 'might' be an auto recycling yard but removing an ignition harness on a modern car intact could be difficult.


How do you replace ignition module in a 98' Malibu?

Remove the ignition module retaining ring. Pull the ignition barrel out. Remove the wiring harness from the back of the ignition barrel. Reverse the process to install the new ignition module.


If your car gets struck by lightning will there be any damage?

My car was stuck by lightning while I was driving. The entire electrical harness needed to be replaced and even after that was replaced we still had issues. The lightning struck the antenna and then arced to the trunk. It melted the antenna and part of the trunk lid.


How do you replace VW Ghia ignition switch?

Begin by removing the retaining ring at the top of your ignition switch. The ignition switch will slide out and you can remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


How do you replace the ignition switch on a 97 ventura?

You will need to remove the ignition switch retaining ring. Pull the ignition switch barrel out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.


Can a wiring harness from a 1981 ford bronco be replaced by a wiring harness from an f-150?

Yes but only from a similar year