0
Purchase an OBD 2 Scanner from Autozone, hook it up to the OBD 2 port located above the brake and gas pedal and see what codes it throws at you and fix it. If that is to technical, then haul it to the dealer, and have them fix it.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you troubleshoot 2002 tundra wont start will crank some sputtering but no start?
your fuel pump could be bad if it runs for a few seconds .
What if car in failsafe mode and wont start?
The car will have to be taken out of failsafe mode to get it to start. The specific way to troubleshoot the problem will vary between brands.
How do you troubleshoot a 2003 focus that wont start?
You don't give anywhere near enough information to even begin - please be more specific.
What can you do to find out why your f 250 7.3 wont start have replaced fuel filter checked batteries still wont start?
If the engine turns over the batteries are fine. Diesels require special equipment to troubleshoot, take it to a shop that is competent in diesel engines.
Why wont my 2005 Ford Taurus SE start. It wont even crank. What could be wrong?
it might be the starter. have it checked out.
Your 2005 f-150 wont start could it be the securilock?
Yes. That is one of many possibilities.
2005 Honda odyssey wont start just clicks?
It sounds like a dead battery
How much would an alternator cost for 2004 aveo?
My alternator just went out in my Aveo. Only place to get one is trough the dealership. They wont $550.00 for one. Try to find someone to rebiuld it.
Your 2005 chrysler sebring wont start could it be the oil?
Unless you ran it out of oil and the engine is locked up, it is not the oil.
Every time i try to get in msn it wont let me it says troubleshoot what does this mean?
you might have a bad connection to the internet.
Why my suzuki gs 500f 2005 wont start I install new battery all electronics works but when i try to start it would'nt even crank it wont do anything but when i push start it starts than shut off?
Sounds like a funky kill switch or safety switch.
Your 2000 rancher 350 wont fire?
Hi you will need to troubleshoot the ignition system. Check out my bio page for help.
