answersLogoWhite

0


Best Answer

I know for my grand am, I have to leave my key in the ignition for 15 minutes.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

10y ago

You first plug it in, then you turn the switch.

This answer is:
User Avatar

User Avatar

Wiki User

11y ago

Flip the light switch into the down or off position.

This answer is:
User Avatar

User Avatar

Wiki User

9y ago

You twist the thing on the side or push it in depending on the lamp you have...

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

Interrupt the voltage to the light, either by turning off the switch that controls it or by shutting of the voltage supply at the breaker.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn off security light?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Natural Sciences

Can I get my ceiling fan to turn on and off by using the light switch?

Yes. Simply turn on the ceiling fan while the light switch is in the "on" position. Adjust the spinning to the level of your choice. Now the fan will turn on and off when you switch the light on and off.


Is there wasted electricity when you turn off a ballast controlled flourecent light?

No, when it's off it's off. A very small and insignificant amount is wasted when you turn the light on.


I want to install a motion detector security light outside can I simply run wiring from where I want the light and join it to the wiring that feeds my backyard porchlight or into an existing outlet?

You could, but you need to have power to the security light all the time, so you would need to make sure that when you turned off the porch light you didn't turn off the power to the security light or obviously it will never some on. I had a pair of ordinary carriage lights outside my garage doors, so I just took the carriage lights down and hooked up the security light and it it fitted directly into the wiring box. I put a plate over the other carriage light box to keep the rain out. Phil


Motion detector security lights won't turn off?

In most motion sensor switches you will have three wires. A black, white and red wire. The black and white (neutral) are used for the electronics in the sensor. These connect to the incoming black and white power. Connect the lamp across the red and the white (neutral). When the sensor detects motion the red wire becomes "hot" and the light will go on.


What will happen if the two switches connected to light up a single bulb are on?

It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.

Related questions

How do you turn securty light off on 1989 Buick Rhetta?

how do you turn off security light on 1989 Buick Rhetta


How do you reset the security light in your 2003 Oldsmobile Alero?

When your security light comes on and your car will not start, turn you key to the on position and wait 10 minutes. The light will go off and you need to turn the key to the off position, then restart your car.


How do you turn off the security light on a 95 camaro?

smash it with an axe as fast as you can


How do i turn off the security light on the dash board on a 2003 montecarlo?

punch it out


How do you turn off security light 1987nissan 300zx?

The security light will blink when either door, hatch, or hood is opened and will continue blinking until it is closed. Check all 4 switches for proper operation. If the bad switch is disconnected it should turn off the light. If the security light is on constantly instead of blinking that is to let you know that the alarm system is activated and should turn off after a few minutes.


How do you turn off security system on 1999 chev suburban?

turn the ignition switch on (all the lights in dash light up) but do not crank engine. leave on for half hour untill security light goes off. turn off ignition, wait 30 seconds then start engine.


What if your car will not start the security light stays on .what do you do?

is your security light flashing? turn the key on, leave on for 10 mins, turn key off let it sit for 2 mins, start car


How do you reset security light on oldsmoblie Aurora?

turn the ignition off for 3 minutes


How do you turn off security light on a 2007 Ford Focus?

find the button or ask how


How do you turn off the security light on an Oldsmobile alero?

I've had this problem where I couldn't start my car and it turns out it was because the security light was on. To fix it: Place the key in the ignition and turn it one rotation (so battery is on) then leave it in the ignition for 10 minutes. Restart car and security light will be off.... also car will start!


1994 camaro Security light is on car starts and runs how to turn off light?

Check the door hood and trunk switches. The security system is telling you that it will not set securely.


Why does your security light stay on on your 1999 Chevy lumina?

It should turn off when the key is turned to the 'on' position.