The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON or START position.
The manufacturer does not recommend deactivating the Enhanced Warning System (BeltAlert).
1. Turn the ignition switch to the OFF position, and buckle the driver's seat belt.
2. Turn the ignition key to the ACCESSORY/RUN position (engine does not need to be running), and wait for the Seat Belt Warning Light to turn off.
3. Within 60 seconds of starting the vehicle, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled.
4. Turn the ignition key to the OFF position. A single chime will sound to signify that you have successfully completed the programming.
The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure.
NOTE:
Although the Enhanced Warning System (BeltAlert) has been deactivated, the Seat Belt Warning Light will continue to illuminate while the driver's seat belt remains unfastened."
The 2007 Jeep Wrangler has 12 valves.
The 2007 Jeep Wrangler has a V6 engine.
The 2007 Jeep Wrangler has overhead valves (OHV).
The 2007 Jeep Wrangler is a gas-powered vehicle.
The 2007 Jeep Wrangler has a 6-speed manual.
No.
The 2007 Jeep Wrangler has a 37.4 degrees angle of departure.
The height of the 2007 Jeep Wrangler is 5 ft. 10.9 in. (70.9 in.).
The 2007 Jeep Wrangler has a 40.8 degrees angle of approach.
The maximum payload of the 2007 Jeep Wrangler is 1000 lbs..
The 2007 Jeep Wrangler is 12 ft. 8.8 in. (152.8 in.) long.
The 2007 Jeep Wrangler runs on regular unleaded.