Chevy Camaro
Chevy Camaro RS
BlackBerry Devices

How do you turn off the governor on a 1998 3800 Camaro?

192021

Top Answer
User Avatar
Wiki User
Answered
2005-10-03 04:48:57
2005-10-03 04:48:57

You need a progammer such as a Hypertech™ Power Programmer

001
🙏
0
🤨
0
😮
0
😂
0

Related Questions


You can't "turn off" the governor, it's computer controlled. Some performance chips may be able to override it but could void your warranty (among other things) - it's up to you if you feel it's worth the risk.

V = ( 3800 mL ) ( 1 L/1000mL ) = 3.800 L

The turn signals are not fused front and/or rear. If the rear are not working you need to check for power and grounds for the lights.

There is not a separate fuse for the rear turn signals. If the rear does not work it is due to a defective bulb or a bad circuit board.

The turn signal relay for a 1981 Camaro should be mounted in on the fuse box. It is on the upper left hand corner.

If you are inquiring about the flasher, it is under the dash on the left side of the steering column sometimes mounted on a bracket.

The 1992 Chevrolet Camaro turn signal flasher unit can be found beneath the drivers side dashboard. The turn signal flasher unit will be above the gas pedal.

It has navigation thru Onstar with turn by turn directions. Visual display with audio.

The 1984 Chevy Camaro turn signal flasher unit is located beneath the drivers side dashboard. The turn signal flasher unit will be above the brake pedal.

i have 20 inch rims on my 1994 camaro and every time i turn the wheel it hits

You loosen the nut own the governor arm turn the arm clockwise and then turn the governor shaft clock wise. Tighten nut That should do it.

The 1995 Chevy Camaro turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be between the gas pedal and the brake pedal.

Right around 235 degrees.

smash it with an axe as fast as you can

My Turn - 1998 was released on: USA: 1 September 1998 (Austin Film Festival)

The selective traction control didn't appear until the 1998 model year but traction control started to be installed in 1995.

if it is a five speed, you have to release the brake and only have the clutch pushed in. my camaro did this last night.

Check the fuses or change the bulbs.

Check for a burned out bulb or could be the turn signal flasher going bad


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.