answersLogoWhite
Dodge Dakota
Toyota RAV4
Toyota Tundra
Dodge Trucks

How do you turn off the seat belt sensor alarm in a 2005 dodge 2500 diesel?

252627

Top Answer
User Avatar
Wiki User
2011-09-12 22:49:38
2011-09-12 22:49:38

Read your owners manual, Its in there. Otherwise there a step process to turn it off. The truck must be turned off, but the key has to be in the on position. There is a process something like lock and unlock the seat belt three times within a certain amount of time, and then lock it for five or ten seconds and unlock turn the kety off, and it stops beeping.

Don't quote me on that exact process, but it is in the Owners manual for sure. That's how I stopped mine from beeping.

1

Related Questions

User Avatar

The speedometer signal comes form the abs sensor on top of the rear axle.

User Avatar

Trouble code P0236 means:Turbocharger boost sensor A circuit range/performance

User Avatar

Yes, a Dodge Neon has a coolant temperature sensor.

User Avatar

The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.

User Avatar

where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan

User Avatar

The crankshaft position sensor on a 2005 dodge caravan is mounted on the top side of the bell-housing.

User Avatar

The Dodge Ram does not use an mass airflow sensor.

User Avatar

The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.

User Avatar

The factory alarm is not removable. It is part of the computer programming.

User Avatar

You have a new vehicle and I am sure it came with an owner's manual. Read it!

User Avatar

The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.

User Avatar

It did from the factoryIt did from the factory

User Avatar

A 2005 Ram 1500 does not have a mass airflow sensor.

User Avatar

The crankshaft position sensor on a 2005 dodge grand caravan is located on the top side of the bell housing.

User Avatar

The crankshaft position sensor on a 2005 dodge grand caravan is mounted on the upper side of the bell housing and can be easily accessed from the top.

User Avatar

It is part of the fuel filter on a diesel.

User Avatar

It doesn't have a mass airflow sensor.

User Avatar

it's on the right front of the engine, not far from the crankshaft sensor

User Avatar

It does not use a mass airflow sensor.It does not use a mass airflow sensor.

User Avatar

Yes, but it is part of the egr valve.

User Avatar

It will run on any diesel sold at a gas station. In colder areas they blend diesel so it does not gel (freeze) in the truck.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.