Chevy Silverado
Toyota RAV4
Toyota Tacoma

How do you turn off the seat belt sensor in a 2005 Chevy Silverado?

303132

Top Answer
User Avatar
Wiki User
Answered
2006-11-20 19:52:25
2006-11-20 19:52:25

Under the seat there is a wire that runs to the seat belt lock. It has a conector which you can unhook. With this disconnected, the bell will not sound while you are in seat without the seatbelt buckled.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions



how do you change the air condition controller in a 2004 chevy silverado


If it is a serpentine belt you replace the tensioner pulley


Answer how to find belt diagram 97 Chevydo what i, had to do ,look underhood of another 97 Chevy pickup.


It does not have a timing belt. It uses a chain.


A/C Belt Power steering belt. Alternator belt Air pump belt.



there is no adjustment for tension on a serpentine belt because there is a spring tensioner the belt goes around and if it is sticking and not keeping the belt tight enough you will have to replace the tensioner. They probably cost more than the labor to do it.


The 2005 Chevy Malibu has a timing chain, not a timing belt.


No you can not. If belt is loose, are won't fit then you have the wrong belt. The belt tensioner is spring loaded and that is what tightens the belt.


how to release serpentine belt tensioner on 1991 C1500 Chevy Silverado?


The 1999 Chevrolet Silverado serpentine belt assembly diagram can be obtained from most Chevrolet dealerships. The diagram is usually provided when you purchase the serpentine belt.


there should be a engine decal on the radiator shroud it will have the directions on how to install the serpentine belt the engine size should be on this decal




use a breaker bar to release pressure on automatic belt tensioner


There is no adjustment on the spring / Tensioner. You either have the wrong belt are the tensioner itself is bad. Replace tensioner are belt.


No you can not, It is kept tight by a spring loaded belt tensioner with a smooth pulley on it. Probley needs a belt tensioner on it.


Where is the diagram for the Chevy equinox serpentine belt routing


You have one belt that runs everything. It's called the serpentine belt. Yours is most likely a 960K6 in the Gates or Dayco belt line.


It does not HAVE a timing belt. It has a timing chain and it will most likey last the life of the engine.


Remove the belt, then remove the bolt in the center of the spring tensioner with a 15mm wrench, install new one


Go to your auto parts store where they know you and ask for a print out diagram for you car's serpentine belt and they will do it for you, I did it the other day!


The clutch fan on a 2004 Chevy Silverado is removed by loosening the alternator bracket and pulling the drive belt. The fan's retaining bolts can then be removed and pulled from the engine.


Loosen tensioner and follow label (under hood) for routing



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.