To turn on the fog lights you pull the end of the turn signal lever it will pop out about 1/8th inch.
Wiki User
∙ 2008-03-21 23:52:40the multifunction switch... ( turn signal) twist it to turn on the lights and once the lights are on pull it towards the door to turn the fog lights on
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
it has a blown fuse
If it does not turn over, but the lights work, you have a bad starter.
Pull the end of the turn signal lever out about 1/8th inch. This only works with the lights on. Fog lamps will not work with headlights off.
Turn headlights on by rotating the switch forward, and then pull outward on the knob to the left. Fog lights will also turn off with use of high beams.
Turn your lights on. If they are dim, or don't turn on at all it's a bad battery. Otherwise it's the starter. Least likely would be an electrical problem like a loose wire or something.
I have a 1998. I have never used the lower lights. Recently asked at the dealership how to turn them on. Lever on left of steering column where I turn on the headlights? The end of that lever pulls out, turning the lower lights on.
No.
on the same switch that turns your head lights on...you should see a little pull switch at the tip, when you turn on the headlights pull it out...it will not work unless the headlights are on
OPen the trunk or hood, pull out the panel and replace the bulb... If that doesnt work, check your fuses
I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.