The connector has a latch/lock on it that needs to be slid over before it can be unplugged. On my Jeep the lock was red and I just sort of pulled the bigger side with my fingernail, since it is kind of small and harder to get, until it wouldn't move anymore and presto I could then just pull the connector loose like any normal plug. Hope this helps.
a 1995 grand Cherokee is obd 1 compliant, The diagnostic connecter is under the hood. It is a black square connector.
On a Jeep Grand Cherokee v6, the thermostat is located in the thermostat housing. The housing can be easily located by following the upper radiator hose to it.
It is OBD I, not OBD II, the connector is under the hood.
The bell housing is between the engine and the transmission.
On a Cherokee the thermostat is under the housing that the upper radiator hose hooks to. On a Grand Cherokee with the 4.7L it is under the lower hose attachment housing.
under the dash right hand side.
The crankshaft position sensor is bolted to the bell housing of a 96 Grand Cherokee. It is at the top of the bell housing, just on the drivers side on a 4.0 L and on the passenger side on a V8.
The crankshaft sensor on a 4.0L Jeep Grand Cherokee is mounted on the top driver side of the transmission bell housing.
under the hood near the pcm and the firewall
It is under the dash on the driver side.
behind engine , on top of transmission housing , slightly to the right side.There is some 30cm of cable attached to sensor and than a connector to instalation.
Jeep Cherokee didn't come with a V8. It must be a Grand Cherokee? Top pass side of the bell housing.
It goes into the top of bell housing.
It is under the housing where the upper hose goes on the engine.
It is under the dash, inside the car.
The OBDII connector is under the dash on the left (driver) side.
To replace a turn signal on a 1994 Jeep Grand Cherokee prop the hood open. Locate the headlight housing and the turn signal will be located next to it. Find the bulb and remove it from the housing. Replace the bulb.
ITS GOT A COOLANT DRAIN PLUG ON THE BOTTOM OF THE RADIATOR HOUSING
It is the area between the engine and transmission.
Under the housing that the upper radiator hose hooks to.
Inside the HVAC housing, under the dash.
The wiring connector is melted. Check wjjeeps.com for pictures and a solution.
Not an OBDII, it is ODBI. the connector is the black "L" shaped connector near the battery.Not an OBDII, it is ODBI. the connector is the black "L" shaped connector near the battery.
It is under the housing where the upper radiator hose hooks to the engine.
It is under the housing that the upper radiator hose hooks to on the engine.