1) Read the manual, act accordingly
2) Like a paper weight
mixer is when you ix the music only but he dj amp i for all the gear like speakers mixers turntables and stuff.............
A HDMI cable is used to connect a behringer mx400 mixer to a behringer head amp. This can be bought at just about an big store.
the difference between a mono block and stereo amp is this: a stereo amp sees half of ohms you give it ( that is if you are trying to bridge it), the mono block see whatever ohm load you give it.
If your amp has a "line out" jack (most likely on the back of amp), you can run a patch cord from the line out jack to an input jack on your mixing board. An earphone jack will work also, but not quite as well, as that is not what it was specifically designed for.
There should be a "signal out" from your board. Monitor send, effects loop. Any number of outputs from a mixer you could use to run another power amp and speakers. Some power amps have a signal out line. Do not hook the speaker outputs to another amp unless you like smoke.
mixer is when you ix the music only but he dj amp i for all the gear like speakers mixers turntables and stuff.............
Sunn o))) amps are popular, if you can get a hold of them. Other than that, most any reliable amp will suffice.
Where is factory stereo amp located on a 2007 Cadillac cts
A mono amp, is half of a stereo amp. It has one input and one output.
Clarify....Are you talking about an AMP for a Stereo?
A mono amp, is half of a stereo amp. It has one input and one output.
The 1997 Grand Caravan Infinity amp can be located behind the stereo system. The stereo system will need to be removed in order to access the amp.
Hook your speakers up to the amp.
if you need mean an amp for a stereo ? yes you can
if you have aftermarket stereo it is very easy pull the stereo out of the dash and take your rca wires and plug them in to the back of the stereo and then take your blue wire which is remote wire and conect it to the remote wire on the back of the stereo, from there you rum the wires to your amp. ground the amp and hook up the sub to the amp and you are good to go. hope this helps.
Yes this amplifier is a mono amp so it is internally bridged. It does not have a stereo output.
No. To use an MD-12 in as a sound re-enforcement mixer, you will need to have a separate power amp.