my ignition is broke and on the on position how can i bypass the ignition n use a toggle for power and a pushbutton to start
run thik power wire from positive of battery to starter. then wire from starter to distributer. then run wire inside or vehicle to push start and ground it or run back out to battery to neg. put toggle switch some where in the process to kill it.
I haven't been able to do everything like that, but to bypass the starter switch, run a wire from the accessory fuse to a toggle switch, and then connect the switch to the 3rd bolt on the starter solenoid.
Just wire it to a toggle switch. When you need it, just flip the switch.
you can just use a toggle switch,,,you need a relay capable of the amps it takes for the starter.it would connect between the starter and the battery,then you would need a toggle switch preferably a momatary toggle switch to activate the relay.
what about the ignition switch wiring
Run a toggle switch from battery to ign. side of ign. switch.
All key systmes are electirical switches. Just like a toggle switch except for with a key for security. Get a switch at a parts store and wire it in between the power source and the ignition. If magneto then wire it to ground the mag.
purple is the trigger wire for the starter. Yellow is the ignition wire.
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
First you need to get the parts automotive grade wire, a fuse link, fuse, and a 3 post toggle switch. cut space in dash of the car large enough for the toggle switch in a place reachable from the driver seat wire fuse link to the positive side of the battery (do not let the other end touch any part of the motor or car this will cause the fuse to ground out) run a wire from the fuse link to the positive side of the toggle switch run another wire from the negetive side of the toggle switch to the nearest ground (area where the wire will touch body or frame of the car) run a wire from the third post on the toggle switch to the positive side of the pump run one last wire from the negetive side of the pump to another ground now turn the toggle switch to on let pump prime (allow to fill with fule) for a few seconds then fire motor
the wire is Yellow coming out of the ignition switch going to the Neutural safety switch, then purple from the neutual safety switch to the starter
I assume you are wanting to manually control the fan. Just run a positive wire from the battery to the toggle switch line side. Then run another wire from the toggle switch load side to the fan. Ground the fan at the fan location. Be sure and use a large enough gage wire to handle the current and an in line fuse to protect the circuit.
The wire connecting the ignition coil primary from the battery marked 'CB' for contact breaker, is usually marked on the coil top. Place a concealed switch in series with this wire. Alternatively place a concealed switch in parallel with the points of the contact breaker.This will stop them 'electrically' opening and stop the production of the spark to the plug.