answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2010-09-22 02:01:00

wire it into the back of the aftermarket steering wheel hub, ive seen many ways so basically u just have a piece of brass or some metal that conducts electricity and u let it touch the rear part of the hub constantly so u basically just bend it into the back, pretty simple =D

wire it into the back of the aftermarket steering wheel hub, ive seen many ways so basically u just have a piece of brass or some metal that conducts electricity and u let it touch the rear part of the hub constantly so u basically just bend it into the back, pretty simple =D

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

How do you remove steering wheel Chevy Cavalier?

Removing a standard steering wheel from a Chevy Cavalier requires taking off the lower steering column and horn button. The steering wheel is held on by mounting screws, after removed be sure to unplug the horn wire.


Mazda 626 horn does not work in steering wheel however if you are using the key chain lock button and you hit it twice the horn will sound fuse is not burnt out maybe the horn relay module in fuse box?

It sounds like the contacts in the steering wheel itself are bad. Find the "hot" wire to the horn under the dash, use a jumper wire to bridge from it to a good ground. If the horn sounds it is bad contacts in the steering wheel. If it still does not sound check for a break in the hot wire between the fuse box and the steering wheel. If the horn relay were bad it would not work at all.


What would cause the horn to sound when 1993 olds is not on?

The car does not have to be running for the horn to work. Horn button in steering wheelt can be making contact, the wire that goes thru the steering wheel and down the column is making contact, any point in the negative side of the horn can cause it to honk. Question. Does it by itself, when car is bumped or rocked, when steering wheel is turned? I would look at steering wheel first. take you horn part of the steering wheel a part and make sure that the plastic in there is not broken or the wires are not of the contections


Horn blowing when I unlock or turn sterring wheel in 1989 Oldsmobile cutlass supreme?

you need to pull the center piece off of the steering wheel and look at the wires in the steering wheel hub as there is a wire that controls the horn that is either loose or shorting out against metal when you turn the wheel.


Crown Victoria horn blowing constantly?

Most likely a short in the wire contact at the steering wheel. Look there.


How do you fix horn problem on a 2002 Ford Explorer that is not related to a factory installed alarm?

The horn wire going to the steering column is undoughtly shorting out. Have it looked at as the steering wheel has to come off etc.


How do you change 1994 Chevrolet astro van steering wheel?

You should be able to pull off the horn button in the middle. There might be a wire going from the button to a hole in the steering wheel, just push in and rotate to remove it. There should be a clip that you pry off. You can the use a steering wheel remover to pull off the wheel. The 1994 Chevy Astro EXT van has 4 bolts behind the steering wheel/airbag/horn assembly to remove the horn/airbag assembly.


How Dow you Fix a Horn on a 1981 Chevrolet C10 Pickup?

the horn has a ground and hot wire .usually only a hot wire because the horn body is grounded.it also has a horn relay.check the wires(wire)and check the relay.if these are good,the horn may be shot.this is all assuming the horn button or contacts at the steering wheel are good.


Remove steering wheel?

1. buy steering wheel removing tool 2. remove horn cap (depending on year, don't lose the horn wire) 3. loosen the main bolt holding the wheel to the column 4. screw the tool on 5. slowly ratchet the tool down to get the wheel off


Does the ribon wire for cruise control come out of the airbag steering circle on 99forester?

Yes, on a 1999 Subaru Forester, the ribbon wire for cruise control is inside of the steering wheel. The same ribbon also controls the horn.


How do you remove the steering wheel on 1964 Chevy impala?

Pop out the horn button, it will just pop out. The horn mechanism is a plastic ring with a rubber and metal retainer for the horn button. Remove the screws (Three) and don't allow two things to happen: Loose the screws and springs, don't let the horn wire touch metal. Remove the steering wheel retainer nut. Mark the orientation of the wheel to centre shaft so you can re install the same. Use your steering wheel puller with included bolts to pull wheel off shaft.


Removal of steering wheel 1994 Chevy S10 4x4 blazer?

I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!


Why would a horn stop working?

It can be a bad ground, bad relay, bad connection, wire, steering wheel horn switch, fuse or even the horn itself could have failed. You'll have to track it down.


Why do your wipers come on when you honk your horn?

Clean the horn contacts(three on the front and one one the back side) and check the ground connection on the steeing wheel. Mine did the same thing when I tested the horn using the switch wire on the steering wheel to test my fix.


How can you disconect the horn on 1996 Chrysler sebring?

Open driver door. Remove plastic fuse panel at end of dash... You have to rotate it counter-clockwise, then pull. Find the 20a fuse and simply pull out. No need to disconnect horn from insde steering wheel pad which requires removing four torx screws near bottom of steering wheel, disconnecting the wire to the airbag then disconnecting the wire from the horn contacts.


Your horn stopped working on your 1998 ford expedition?

Checked the fuses. Tested the horn, direct connection to the battery. Check horn relay. Here is the basic. Between the horn switch and the horn relay is the Clockspring Assembly in the steering wheel. If you ground the red/green wire at the base of the steering column and the horn works, you have either a bad horn switch or Clockspring Assembly.


How do you replace a horn on a Honda Civic 1995 CX?

i think it's pretty rare that it would be the horn, probably loose wire in the steering wheel. but the horn is located behind front bumper cover passenger side.


How do you remove the steering wheel on a 1992 Toyota Tercel?

Remove screw @ bottom of horn pad. (After disconnecting Neg. battery cable of course.) Disconnect horn wire from pad. Remove center nut. Use wheel puller and REMOVE.


How do you repair horn on a 1995 Chevrolet silverado?

is the wire hooked up to the horn outside ? next is the wire hooked up to the press pad on the steering wheel the place that you touch to blow the horn? is the fuse good if all these things are good then it,s time to pull the steering wheel and that is a real chore under there ( beware ) you can cost your self a lot of trouble under the steering wheel . and just getting it off can be a hassle for a lot of folk,s if you have to pull the wheel get a book and go from there .trust me it,s a chore in it,s self like a rok 45 freak over N out


How do you disable the steering wheel air bag and remove steering wheel on a 1990 sedan deville?

Do not do this during an electrical storm. Disconnect negative battery cable. Wait 10 minutes. Remove the bolts holding the airbag bodule/horn pad to the steering wheel (from the back.) Hold the airbag module with one hand, then with the other hand unplug the horn wire and airbag wire. Move the airbag module away from the car. Set it down someplace out of the way and face up where other people won't go near it. Remove the nut and circlip at the center of the steering wheel. Use a steering wheel puller or two-bolt puller to pull the stering wheel off the column.


How do you remove the steering wheel in a 1988 Chevy Celebrity?

To remove the steering wheel in a 1988 Chevy Celebrity standard version: !. Remove the screws that hold the horn pad in place then remove it. Unplug the wire at the connector. 2, If it still has the safety clip remove it. 3, Use the appropriate wrench to remove the nut from the steering shaft. 4. Use a steering wheel puller to loosen then remove the steering wheel. Reverse the instructions to replace the steering wheel. Steering wheel retainer nut should be 30 ft. lbs. torque.


My Mazda millenia's 1998 horn is not working and the problem is in the steering system I need some suggestion for an alternate and cheap car horn system.?

Cheapest, simplest way is to get a horn button at a parts store and run a wire from the battery to the horn. Just like a large door bell button. Not as convienent as the steering wheel but serves the purpose.


How does a horn get stuck on in a 1996 Saturn SL2?

Three usual suspects: #1 the switch contacts in the steering wheel can wear and get stuck together, or the wire running through the switches, roll connector (connects the part of the steering wheel that turns to the rest of the car that doesn't) to horn gets frayed and grounded or #2 the remote keyless entry (RKE) module is defective or #3 the wire from the RKE module to the horn module has frayed and grounded. Anything that grounds the "B" terminal on the horn will cause it to sound.


What can go bad that would result in the horn continuing to blow?

the switch in the steering wheel is stock on or the relay for the horn is stock on. for the stock steering wheel, remove the round cap with a large screwdriver (there is a special spot) once the cap is removed, place the steering wheel straight right, at 10h position (on a clock) there is a stud an a spring device, you can pull the out, if the horn is still blowing check the relay. the relay is positioned over the passenger feet. the relay is yousualy white and neer the blue box, you can remove it with your hand. if the horn still blow, cut the wire...


Horn does not work on your 2004 stratus fuse is ok?

check the voltage at the horn and see if its getting 12 volts. If it is getting 12 volts then the horn is no good. If its not getting 12 volts then the wire from the horn needs to be traced back to see if there's a break some where in the positive wire. try checking to see if the horn button on the steering wheel is working properly.