the answer to this qustion depends on whether or not you want a retractable stylus. for a non-retractable stylus get a gel pen. what you will need to do is take the pen apart and cut the knob of the ds stylus. it should look like a stick shaped stylus and should be able to fit into the pen if the stylus is too short/long; i would cut it down to the right lenght. after you get it to be the size you want/need; put it into the pen and test to see if it works ( tip of stylus should stick out of the pen tip.) if it works the pen back toghter and you have your stylus and you can put the pen cap back on to keep the tip clean. my pen i used was a sanford uni-ball gel grip pen. i took the pen apart and to get a tube. i put airsoft bbs in it because the stylus was still too short. but before i put the bbs in i put a spring from pilot g-2 07 pen and put in in the bottom of the pen. put 6 bbs in the pen and the ds light stylus and the tip of the pen is too small; so i i took a pice of sandpaper and filed the pen tip down till the stylus tip came out.
now if you want a stylus that is retracable i took a pilot g 2 07 pen apart and took the spring out and put that in the botom of the pen and 3 bbs the pen. the hump doesn't have to be cut off for this; but put the stylus in and put the pen back toghter and you have a retracble stylus. to work it; push firmly on the clicker part ( the part that you push to get the tip to come out) and to get it back in push the button agen and just use your finger to push the stylus tip back in. it works realy good and i bet it would work with anything that needs a stylus.
good luck
A stylus transfers the energy from your body to the tip of the stylus
we never change ours unless there is anything wrong with it
I believe you are inquiring about a "stylus".
download usb driver
No, however, it does mean the air bags won't work if there is an accident
The Etch-A-Sketch contains very fine aluminum powder, which sticks to the glass. The knobs are connected to wires and pulleys, which move a plastic stylus vertically and horizontally. The stylus scrapes a tiny amount of the aluminum powder off the glass, leaving a visible line. If you draw all over the screen and clear away all the aluminum powder, you can see the mechanism inside.
you can use your pen or your finger as a stylus.
stylus
stylus
Based on what I found at the Epson website, the following list is compatible with the Epson T0801 Black Inkjet Cartridge:Epson Stylus Photo P50Epson Stylus Photo PX650Epson Stylus Photo PX660Epson Stylus Photo PX700WEpson Stylus Photo PX710WEpson Stylus Photo PX720WDEpson Stylus Photo PX730WDEpson Stylus Photo PX800FWEpson Stylus Photo PX810FWEpson Stylus Photo PX820FWDEpson Stylus Photo PX830FWDEpson Stylus Photo R285Epson Stylus Photo RX585Epson Stylus Photo RX685I hope this helps. Let me know if I can assist you further.
I have a magic trick for you, where it looks like the stylus is going right through your stomach! here's how you do it:get a Nintendo 3ds stylus.pull up your t shirt.make sure the stylus is fully extended.put the sharp end of the stylus in your belly button, being careful not to hurt yourself.with your hand, make the sharp end of the stylus hidden from view.un-extend the stylus. it will look like the stylus is gone through your stomach!extend the stlyus again.carefully take the stylus out.Show other people it!!!
A Poyo Stylus is A Stylus for your Ipod touch or Iphone. You can use this Stylus instead of your finger. (Buy it at Amazon)
No, it does not come with a stylus. You can operate the touch screen with or without a stylus.
It's called a stylus.
It's a little hard to explain, but go to howcast.com and type in how to make an iPad/iPhone stylus, or go on YouTube and type that in.
A stylus is a pointed tool of somekind.
A good drawing stylus and probably the best for the iPad is the Wacom Bamboo Stylus.
Yes, it is sold with a stylus.