I just replaced a blown third brake light bulb today. ... I have about 60k on my M and havent yet had to change the brake light---so if it only has to be done once in the ... If memory serves, the Concorde's is in the rear window. ... Well I decided to mod my 2004 300Mspecial Third Brake lights, not with a bulb ...
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
Dot 3
Parking brake not adjusted properly? Frozen brake caliper?
You will need to use the universal brake lines sold at auto stores. You can check at a Chrysler dealer but I think they are discontinued there.
The bleed screw is by the thermostat housing it looks like a brake bleed screw
the turn signal/hazard flasher is located under the dash between the brake pedal and the fuse block.
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
You will need to call a locksmith unless you want to brake a window.
one common reason is that some brake fluid may have leaded out of one of the front wheel brake cylinders. Usually the car will jerk to the opposite direction of the leaking brake cylinder. Check the inside of the the wheel/tire and see if there are oil stains from the leak. if so you can replace the brake cylinder or sometimes change the dirt seals on the brake cylinder.
Tires,inner tie rod bushings, if the steering wheel shakes when brakes are applied - brake rotors warped.
gsdh.org - Ultrashock Forums 4 posts - 3 authors - Last post: 18 Apr 2008 Bookmark and Share! gsdh.org. Old 2008-04-15. There are no ratings to display ...and that is the right answerget stuffed