I believe all 93-98 Grand Cherokees are the same but basically you just pull and pry (gently of course) until the whole headlight pulls...well pops really...out. Then you have access to the back of it to change the bulb and it just pushes back in. It is a little tricky and i think a screwdriver works best but really be careful what your prying against because most of it is plastic and can crack. Taking this out will also give you access to the screws holding the parking/turn signal lights.
I've got a 1996 Jeep Grand Cherokee Laredo V8 w/ Quadtrac & have had to replace some light bulbs in it. To get the headlight off, you have to unscrew the top screw which is in the corner closest to the fender, and then there's another screw between the headlight & the front blinker even though there's absolutely no room. I could find no way to get a screwdriver or any other took to fit in there & the repair shop had no idea how to replace it. I was told by a friend that you can get an Allen wrench in there? I ended up breaking the brackets for the bottom screws on both headlights, but you can keep the headlight staying in with just the top screw.
Where is the 1994 JEEP grand cherokee Daytime Running Lamps Lights Module? Lights are working but the running lights and dash board lights are out.
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
take it to a garage SMARTY
Time for an oil change.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
On my 1993 Grand Cherokee, it is located just below and behind the water pump.
Time for an oil change.
it means its time for on oil change
How do you install passenger tail light kit for a 2004 grand cherokee?
you prolly just need an oil change
Yes.
The car actually measures the viscosity of the oil while you are driving and running the car when you change the oil the light will be reset.