What do you mean by headlight cover?What are you trying to do?JW
You need to remove the rear seat to access the speakers and remove the covers.
remove the spark plug cover. and the valve cover to reach it its right under the cam pulley
The 1999 Pontiac Grand Am speakers can be removed by removing the speaker cover. The speaker cover is held in place with two screws. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.
remove wheels, release emergency brake and drums will come off.
The 1995 Pontiac Grand Am 3.1 liter engine crank shaft sensor is located inside of the rear engine cover. You will need to remove the rear engine cover in order to access the crankshaft sensor.
Follow the upper rad hose to the engine. You will need to remove the engine cover. To remove the cover turn the oil filler neck (not the cap).
In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.
where is valve cover located on a 2001 Pontiac Grand-Am 4 cyl
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
on top of the engine there is a cover sheild. remove the cover by the four bolt. the plug boots will come with it, the spark plugs are down in the holes.
If your key is stuck: on the underside of the steering column cover there is a round recess cover. Remove the cover and using a pecil push up through the recess.
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you remove the brake light cover on a ford focus
The 1997 Pontiac Grand Prix rear deck speaker covers are held in place by four retaining screws. Remove the retaining screws to remove the covers.
How do you remove cover to replace brake light on 57 kia Rio
with a wrench.
If it is anything like the '96 Grand Am, it is located under a cover between the engine and firewall. The cover has 3 bolts in it. Remove the bolts and the cover and you will find the O2 sensor (front - the other is just after the catalytic converter.) You will need a 7/8" wrench to remove the part.
On the bottom of the dash on the passenger side remove the black cover then remove the bolts on the blower and disconnect the wire. Reverse above to install.
Dust cover on what?
on the back of the fuse cover....
Follow the large hose on the top right of the radiator back under the plastic engine cover. Thermostat is inside the metal cover at the end of the hose. Remove cover with 10mm socket.
to get the oil filter out you need to remove the black cover in front of the cross member by the two wing bolts and then pull the oil filter through there.
To remove brake cylinder from Corsa B, first disconnect and unplug hydraulic lines. Remove the nuts and the master cylinder. Remove the reservoir cover, followed by the brake cylinder.