The are four screws that need to come out. Two are located under the cups holders/accessory mat. You have to remove the entire piece. There are two star headed screws, one under the rubber mat and on under the front edge of the console door. The screws you are going for and down each side of the console about 8 to 10 inches from the front on the outside of the air chamber. The second two are towards the back on the outside, they have trim covers hiding them. Once these are all out, PULL the entire console away from dash. It must slide about 4 inches back and then it will be loose.
Any "same year" Ford Expedition seat will fit. I just replaced the center console with a 2004 Expedition seat.
In center console...
Check your owners manual. If you don't have one copy & paste this link. http://www.genuineservice.com/genuineservice/en/gloveboxresults On my 1999 Expedition the center console 12v power fuse was under the hood. It's a 25A fuse and the manual recommends disconnecting the battery before replacing. (I did not disconnect the battery)
In mine...the factory mounted CD player is in the center console.
The Original Ford Expedition 6 Disc CD changer with Magazine. Goes install inside the center console. Between the two front seats.
getting the center console out of a 2005 caddillac escalade
The 1995 Pontiac Grand Am center console is held in place with for retaining bolts. Remove the shifter knob. Remove the center console retaining bolts. The center console will come off.
If you have a center console, that is where you will find it. If there is no center console it is in the trunk.
If I'm not mistaken there's bolts inside the console under the rubber mat and under the rubber mat in the cup holder area and the little storage compartment My 05 Expedition has the same bolt/screw under the mat. After removing it, I had to pull the top section (the compartment that you took the screw out of and the cup holders) out, it was kinda tuff, but there are six spring clips that continue to hold the top to the bottom of the console. One at each of the corners, and one on each side of the center of the console, where it makes the bend.
Center console, remove two stud nuts.disconnect power first, before replacing
The center console on a 1988 Honda Civic is mounted using several screws. Locate and remove all the mounting hardware to pull the center console off. After the screws are off gently pull the center console out.