Auto Parts and Repairs
Chevy S-10
Mazda Trucks
Toyota Trucks and SUVs

How does one replace a starter on a 1991 Toyota pick up truck?

343536

Top Answer
User Avatar
Wiki User
Answered
2005-10-16 22:41:07
2005-10-16 22:41:07

if its a v-6 remove the RF tire, remove the 4 10mm bolts on the inner fender shield and the clips that secure the rubber shield. this will give you enough clearance to remove the starter. remove the front splash shield and you can see the starter on the passenger side of the engine. remove the small wire, remove the large wire with a 12mm socket on a long enough extension to reach it from the bottom of the veh. The rest is acedemic, a couple of bolts and a little twisting of the starter it will come out right through the wheel well.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The starter on a 1991 Toyota Tercel is located in the front of the engine. It will be located on the left side.

changing front brake pads on 1991 Toyota truck

How do you replace starter on2.3 cy 1991 pontiac grand am

A diagram of a 1991 Toyota starter relay switch can be obtained from most Toyota dealerships. The starter relay diagram can also be found at most auto-parts stores.

On a 2wd 1991 Jimmy S15 the starter is under the motor. The easiest way to replace one is to jack up the front end with a floor jack which will give clearance above the tires. Above the passenger tire you will see the starter under the exhaust manifold, you can get to the wires this way. Then you get under the truck and take the two starter bolts out

How do you prime the oil pump on a 1986 Toyota truck with 20r/22r engine

Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft

replace heater core in a 1991 Chevy work truck 1500

CV boot? Tierod boot? Ball joint boot? Driveshaft slip yoke boot? If its torn REPLACE it

I use a starter solenoid from a 1991 - 1995 Toyota Pickup on my 1998 FLHT Evo... and a fraction of the cost from Harley.

The solenoid is part of the starter.

I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup

Disconnect the positive battery cable, and replace the starter. 2 bolts, a couple of wires , and replace it. It's just that simple.

Fuse block in engine compartment right side.

Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.

Slide in under the truck behind the passenger side front wheel and look up at the rear side of the engine and you will see the starter.

How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?

try this nathan-buchanan@tulsa.edu good luck

Under the dash behind the cruise control actuator, or so I have read.

Make sure the starter is bad then remove the neg battery cable then the wires from the starter, take the bolts out that hold it on and work it out.

99.9% you cannot do that. Toyota parts are not compatible with Honda parts. Radiator & starter no way will the fit. Alternator it is possible if the mount is the same.

Need a diagram to set the timing Mitsubishi 1991 pu

On Engine, drivers side, under intake. Very tough to replace. Bad Toyota!

Remove the front bumper to remove the radiator


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.