answersLogoWhite

0

  • Water Pumps
  • Oldsmobile Ciera
  • Chevy Blazer S-10
  • Ford Explorer Eddie Bauer

How does the pully come off the water pump on a 1987 Olds Cutlass Ciera 4 cylinder?

User Avatar

Wiki User

βˆ™ 2008-05-09 10:47:40

Best Answer
Copy

I recently replaced pulley on Power Steering pump by taking it to a local garage they have a special puller to remove it and press it back on the new pump cost about 10 dollars

2008-05-09 10:47:40
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

Where is 1986 Oldsmobile cutlass ciera water pump at?

It varies by engine.


Where is the water pump in your 94 Oldsmobile cutlass ciera?

On the front of the engine.


How do you remove the water pump pulley on a 1985 Oldsmobile cutlass ciera?

pulley puller


How long does it take to change a water pump in a 1996 Oldsmobile cutlass ciera with a 3.1?

bum willy bum


1994 olds cutlass ciera water pump and is there a housing behind it that leaks and has a gasket?

yes water is coming out of this little hole in the water pump


Where is the thermostat on a 1993 Oldsmobile cutlass ciera s located?

The 1993 Oldsmobile Cutlass Sierra thermostat is located on the front of the engine. You can follow the water supply line from the radiator to the thermostat housing.


What causes a 1990 cutlass ciera hesitate and sputter when gas pedal is depressed or crusing and symptoms stop when brake is applied?

A 1990 Cutlass Ciera might hesitate and sputter when the gas pedal is depressed because of water in the fuel or because of damaged or dirty fuel injectors. You might also have an issue with the wiring or the distributor.


Where is the water pump on a 6 cylinder 99 olds cutlass?

On a 1999 Olds Cutlass, the water pump is located in the engine compartment under the hood. It is on the motor on the passenger side of the vehicle.


Where is the water pump a 1994 Nissan pickup?

On the four cylinder it is directly behind the fan pully. on a six cylinder it is behind the timing cover and is timing belt driven.


1994 Ford Probe squeals when started?

I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose


How do you take off the water pump pully off of a 91 Chevy Lumina without the pully turning?

wrap the belt around the pully to hold pully still


Where is the cam positioning sensor on an 1987 Olds Cutlass Ciera with a 3.8 V-6?

the cam position sensor is just below the water pump pulley in the front timing cover. Master


Why does the temperature light on a 1989 Olds Cutlass Ciera come on for a few minutes then go off after the water pump was replaced if there is no smoke or leaking and the car does not run badly?

You may want to consider replacing the thermostat.


What tools do you need to replace your water pump on a 1996 olds ciera?

how to change water pump on 1996 olds ciera and what tools do i nees


Where is the water pump on a 1995 olds cutlass supreme?

Where is the water pump on a 1995 olds cutlass supreme?"


Where is the water pump on a 1999 ford escort zx2 4-cylinder?

it runs off serp belt. its toward yhr ft. there 3 bolts holding pully to pump. not much harder than taking belt off.


What type of coolant does a 1995 olds ciera take?

If you referring to the anti-freeze/coolant. Any name brand coolant will be fine. I have a 1995 Oldsmobile Cutlass Ciera, and I recently flushed and refilled the coolant system. I used PRESTONE. I used to 50/'50 mix they sell (already mixed). That way you don't have to mix your own antifreeze. The recommended mixture is 50/50, that's what is recommended for the Cutlass Ciera. Other mixtures are 70 (coolant)/ 30 (water). If you are going to mix it yourself make sure you use distilled water, and make sure you mix it prior to putting in the vehicle. The short answer though, just get some Prestone 50/50 anti-freeze. That's your best bet.


Where is the water pump in the 1991 Geo Metro engine?

look at your belts. the pully between your motor and the altenator. This is your water pump pully. The back end of the unit should be attached to your motor block.


What size are water pump pully bolts for 1998 Saturn sc2?

10mm


How do you remove the pully from the water pump on a 1989 Pontiac Grand Am?

Remove the bolts in the front of the pully it's a tight spot a ratchet wrench works pretty good here.


How do you remove water pump from a 1992 infiniti g20?

the water pump is located on the left side of the engine mid way down. remove the belt and then the pully. the pump is located behind of the pully. there is not much room and it is not easy to replace,


Removal of water pump pulley 1994 Chevy cavalier 2.2?

I have a knocking noise near the water pump pully or idler arm pully on my 94 chevy cavalier 2.2 motor when its at idle, if i give it more gas the noise will go away do you know what this could be? i took off the tension idle pully and checked the bearing and it was fine.


Water circulates around a water cooled engines cylinder head and cylinder inside the water?

The water jacket is on the out side of the cylinder and in side the out side casing. If you are wanting to know what is in the water it is anti freeze.


If the leak is coming from behind the pully does the water pump need changing?

Yes. The seal for the water pump is bad. Replace it.


How do you replace a water pump in a 89 Toyota Camry?

The water pump is located under the timing belt/ front pully cover you need to remove the front engine mount,all belts, crankshaft pully, then remove the cover ( its in two parts) and the camshaft /timing belt as it drives the water pump. Good time to also replace the belt. best to remove the front wheel to get at the crankshaft pully