Fuel and Engines

How does water get into an engine?

777879

Top Answer
User Avatar
Wiki User
Answered
2007-10-15 18:33:21
2007-10-15 18:33:21

Usually when the cylinder head gasket is blown (broken or damaged). It cannot be repaired but has to be replaced with a new head gasket.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


The Water Engine was created in 1992.


The water in the engine of MMW I helps cool the engine of the vehicle.


The water pump is usually on the front of the engine.


Yes, you can wash your car engine with water.


The radiator cools the water which then goes to your engine to cool it off, as cool water enters your engine hot water from the engine enters your radiator


Yes, water cools your engine. A water pump draws water from the radiator and into pores in the engine block, cooling it off. There is a thermostat that lets the hot water out of he engine at a certain temperature so the hot water cools off in the radiator with wind and the cold water goes in the engine.


The water pump for a 3sfe engine is on the back and bottom of the engine. It is on the passenger side of the car.


There is no engine that runs on water as its energy source.


Yes. You can freeze the water, making it expand, or you can add cold water to a hot engine, shocking the block. You prevent freezing with antifreeze. You prevent shock by never adding water to a hot engine. If there is enough water in the engine to have the water pump provide circulation, you can add water SLOWLY, but you should really only add water to a hot engine when there is very little to add.


A Liquid Cooling engine works by using Water and Ani Freeze to travel from the resevwar to the engine via a Water Pump, and it travels through water jackets that cool the engine down. when that water gets to hot the Thermostart opens to let water out from the engine through the return pipe and goes through the radiator fins to cool the Hot water down, then goes back into the engine to cool again.


The engine will overheat quickly and catastrophic damage can occur if you continue to run the engine.


Water belongs in an engine. Now if you mean if there is water in the oil in an engine, this may mean that you have a blown head gasket. This needs repair before you drive the vehicle or it can do serious damage to the engine.


The water cooled engine will typically be heavier, because you have to add in the water pump, the radiator and the water/coolant. The engine block itself may be lighter as there are passages drilled out for the water/coolant to flow through.


Most, but not all water pumps are located at the front of an engine


it circulates the water throughout the engine and the radiator, keeping your engine from overheating


For cars, water can overheat the engine and can also seize the engine


YEs! Don't let water in your engine or it's toast!


Start the engine. The water will evaporate from the heat generated by the engine.


A small amount of water, engine will idle poorly and lose power. A large amount of water, engine will cease to run.


there is water in the engine to cool it down. It is best to use a 50/50 mix of clean water and antifreeze, not just water.


Absolutely not!! Unless you want to replace the engine. Water does horrible things to engines and that is the reason water isn't used for engine lubrication and pure water isn't used for cooling the engine in the first place.


There will be no water pumped into your engine to cool it, then you might need a new engine.


A steam engine uses water, steam, and heat.


Fuel pump is what pumps gas to engine. Water pump is what pump water in engine


The water pump is bolted to the front of the engine behind the engine cooling fan



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.