Asked by Andy Blackwell Uncategorized
How dpfe sensor works?
We need you to answer this question!
If you know the answer to this question, please register to join our limited beta program and start the conversation right now!
How do you fix a 1998 Ford Ranger pickup with an error code of 1401?
1993 Lincoln town car is DPFE sensor the same as EGR valve position sensor if not where is the DPFE sensor located?
Asked in Ford Crown Victoria, Ford Expedition XLT
Where is the DPFE located on a 2002 ford crown Victoria?
Asked in Ford Windstar, Ford Windstar GL
What does a diagnostic code P0401 mean on a Ford Windstar?
What causes a P1405 Error Code on a 1998 Ford Windstar?
Where is the DPFE sensor on a 2002 Mercury Mountaineer?
Where is the dpfe sensor located on a 1994 Lincoln town car?
Asked in Car Computers and Sensors, Ford Explorer, Ford Trucks and SUVs, Ford Explorer Sport, Ford Explorer XLT
Where is the dpfe sensor on a Ford Explorer?
Does anybody knows the meaning of trouble code P1400?
The code P1400 reads "DPFE Sensor Voltage Low" (Ford, Mazda). Often it's caused by a bad DPFE sensor or clogged EGR passages. DPFE stands for (Differential Pressure Feedback EGRI) I would clean the EGR valve which cost nothing. If that does not cure the problem, you may need to replace the DPFE sensor, which does cost, and it may not fix the problem. If you want to be sure you replace the correct part, then visit your local Ford dealer. dpfe stands for delta pressure not differential.
What does it mean when a 1999 Mazda Protege shows a p1170 code?
Asked in EGR Systems
What is likely cause of code 1401 after DPFE sensor replacement and EGR cleanup?
P1401 - DPF EGR Sensor Circuit High Voltage Detected The EGR monitor checks the DPFE sensor signal to the PCM for high voltage. The test fails when the average voltage to the PCM goes to a voltage greater than the maximum calibrated value. Possible causes: DPFE circuit open VREF short to PWR Damaged DPFE sensor DPFE circuit short to PWR SIGNAL RTN circuit open Damaged PCM Look at scan data stream for a reading greater than 4.5 volts with the key ON and engine OFF or running. This indicates a hard fault.
How to solve the code P0402 in a 1998 ford contour 2.5 LX?
A P0402 indicates that the PCM is seeing voltages higher than expected from the DPFE(Delta Pressure Feedback Exaust) sensor. The DPFE is the EGR position sensor. The high than expected reading could be caused by an EGR valve that is either sticking open, EGR valve that is being held open by the EGR vacuum regulator, or it could be a faulty DPFE sensor.
Asked in Toyota Camry
Where can you buy a dpfe sensor for 98 Toyota Camry?