Steering and Suspension
Chrysler Sebring
Honda Civic EX

How expensive is it to have tie rods repaired in a Chrysler Sebring jxi?

555657

Top Answer
User Avatar
Wiki User
Answered
2015-07-15 19:59:55
2015-07-15 19:59:55

i just had the outer tie rods changed in my 1998 sebring convertable, it costs 65 for each rod, and the charge about 60 a side, total was about $250.00

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.


It can cost between $60 and $250 to change the tire rods on this car. It will depends on where the person gets the parts and the labor charges.



Trunk props,or prop rods. They are "gas struts"Trunk props,or prop rods. They are "gas struts"


Basically, it's off with the old and on with the new. However, there are a few tricks to the task. Check out this website for some of the specifics: http://www.ehow.com/how_4509233_replace-tie-rod-end-chrysler.html Now, go "tie" one on.


Parts plus labor will run you around $450 per side.


Saltwater,Saltwater rods are typically longer and stronger than freshwater rods. I personally use saltwater "Surf" rods for freshwater fishing.www.southernohiopaylakes.proboards.com


Cabelas fishing rods ranges from cheap to pricey so one will have to decide which they prefer. One can ask friends and fishing buddies for help if they need help in finding good fishing rods.


Parts around - $70 Alignment around - $70 Labor around - $150


Tie rods, water pump, all air conditioner components,....


It was not built with any. Replacement parts such as outer tie rods may have them though.It was not built with any. Replacement parts such as outer tie rods may have them though.


No, they are like 25.00 ea. Labor though is extra & you have an inner/outer (2) ea. side.


There are old rods, good rods, and super rods, and super is the best.


they are not that expensive under 50 bucks if i remember i had to change mine it was not that bad.


Nuclear fission is extremely expensive when everything goes right. When things go wrong it is even more expensive. People haven't found a safe place to put the nuclear trash (spent fuel rods) yet.


In 160 rods, there are 160 rods. This is a funny question.. ha ha ha. not.



There are a variety of rods, such as curtain rods, lightning rods, stirring rods, etc. They are generally made from metal or wood, but stirring rods can be made of glass or plastic.


20-rods x 80-rods = 1,600 square rods = 10 acres = 435,600 square feet


I assume you mean 'Tie rod ends' , - obviously cost depends on vehicle. More expensive and bigger vehicles have more expensive parts. Tie rod ends for a 2004 Windstar are about $45 each.


rods are used for fishing


No. Some less expensive guitars do not have truss rods in their necks. Any guitar that is more than a toy should have a truss rod, with out the truss rod if your guitar got into some moisture and the neck bowed,you would not be able to straighten the neck out.


There are many brands of fly fishing rods available. Some of the most popular brands of fly fishing rods are G. Loomis Fly Rods, Sage Fly Rods, and Albright Fly Rods. Other popular brands of fly fishing rods are Redington and Cabela's.


1 yards = 0.181818182 rods2 yards = 0.363636364 rods


1 mile = 320 rods.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.