Right when you flick the switch to turn on the light the socket connects and the light will automatically turn on.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
Electricity is the type of energy that is used when you turn on a light bulb. When you leave a room, you use more energy by leaving the light on than if you turn it off and back on when you return.
when you have your lights on, if you pull the switsh outwards, this will turn your fog lights on, the bulb is just to tell you your fog light are on.
How to turn off the backyard sensor light
The size of the bulb isn't related to the time in which it will burn out, it's related to it's quality and how many times you turn it on and off.
the front bulb needs to be replaced.
Wrong light bulb.
Usually when ones turn signal is blinking fast its telling you that a turn signal bulb (and in some cases a brake light bulb) is out. If it blinks fast when you turn on the the left signal the burnt out bulb is on that side of the vehicle (could be front or rear bulb so you'll have to check). And vice versa
The turn signal and brake light use the same bulb. When you get a fast flash, it is from a reduced electrical load being placed on the flasher unit due to a burned bulb. Replace the bulb and this should fix your problem.
you have a light out that way it signal fast
Remove the turn signal light bulb connector. Take hold of the light bulb, push in and turn at the same time, to remove the light bulb. Reverse the process to install the new light bulb.
It means one of the lights is burnt out or loose and is not working. Turn on the turn signals and get out of the car and see which bulb is not working. Replace that bulb.
the bulb with two elements in it is the turn signal and brake light bulb
The front turn signal light bulb can be accessed through the engine compartment. Take hold of the light bulb connector on the back of the turn signal. Push the connector in and turn at the same time. The light bulb will come out.
Usually means the bulb is out. Turn on the turn signal then go out and see if the signal light is flashing.
A fast flashing turn signal, on most any vehicle, is an indicator that a turn signal bulb is going out or has gone out on that side(i.e. front turn signal on passenger side flashing fast, check the rear turn signal bulb on passenger side.) This will cause the light on your dash board to flash fast as well. This is generaly a good time to replace all of the bulbs, turn signal, running lights, and break lights, as they are so cheap. Also check deck light or top break light if applicable for burn outs.
yes, there is a gas in a light bulb you energise it and it glows.