I believe it is similar to my suzuki 500 the two side cover gaskets (clutch/magneto) are easy for someone who has experience, the crank case gasket at the center of the engine is very hard.
The engine would have to be taken out and almost completely dissembled to get to the center crank case gasket, at this point it may be easier to get a used engine, or if your going to keep it for a while you can rebuild the engine you have.
If your engine is leaking a little bit of oil, you can try some epoxy, clean the area with some sand paper and solvents to remove all oil/grease
jaguar 2001 Lower Engine Intake Manifold Gasket
how to replace valve cover gasket toyota rav4 2001
sure
Remove the old head gasket and put the new one in its place. Pretty simple
If it is a 2.7l engine it is a good four hours, and that is on a good day
take the serpentine belt off and then take the crank pulley off the balancer and then you will need a puller to get the balancer off the crank.
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
either sell the car or pulley engine out
Yes, no matter what part u change, if there's a gasket involved, u always replace the gasket. Make sure u clean both surfaces.
how do u change a crankshaft sensor on a Oldsmoilbe alero 2001 2.4L twin cam?
Step 1: But the appropriate Service Manual. Step 2: Read it.
Being surprised my 2001 Suzuki Grand Vitara (same as Tracker) had a drain plug for the transmission. I just change the fluid, not the filter or gasket.