answersLogoWhite
Car Starting Problems
Cadillac Seville
1995-1999 Dodge & Plymouth Neons
Hard Disk Drives

How hard is it to install a new starter motor on a 1998 STS do you need new intake gaskets?


Top Answer
User Avatar
Wiki User
2006-10-03 23:30:18
2006-10-03 23:30:18

not to tough and no gaskets required, do not remome the intake just prop it up with a broom handle shoved from across the front head to the intake mounting surface of the rear head and reach under from the passenger side.

Related Questions

User Avatar

starter is located under intake plenum on 4.6 cadillac motor .which is the engine valley between cylinder heads.Can be replaced without changing intake gaskets if careful about lifting intake plenum/gaskets are silicone rubber and can be reused if not damaged

User Avatar

To install a 1995 VW golf starter, remove the motor mount. Disconnect the wiring on the motor step and install the starter.Ê

User Avatar

The starter motor is located below the intake and throutal body.

User Avatar

Probably a gasket leak. Could be the intake gaskets or the thermostat gasket.

User Avatar

the starter motor is behind the intake manifold. after you take the main intake shield, there is another shield that covers the starter motor. remove the starter shield and you can find the motor. its a little hard that other cars i used to have but it can be worked on. just need a little more patience.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.