that is an easy job. disconeect the wires, unblot the solenoid.install new solenoid, reconnect the wires. jobs done
the solenoid is mounted on the starter. They don't mount them on the fenderwell anymore.
Depending the which Hyundai the starter will have to be reach from either underneath the vehicle or above. First disconnect the battery and remove the starter mount bolts. Disconnect the solenoid and remove the old unit. Replace with a new part.
There will be two smaller wires that mount to the starter solenoid. These mount to the same post on the solenoid as the battery cable. The last few inches of this wire is fusible link. Many times the link melts and people will replace it with regular wire. It's there to protect your vehicle wiring. If it's missing, I highly recommend replacing it with fusible link.
Yes , fuse # 2 , 7.5 amp for High - mount stoplamp on your 1996 Explorer
You've got 4 mounts total. A transmission mount, then on the other side of the motor, you've got a mount that goes to the middle of the engine that is in the fender, and upper torque strut and a lower torque strut on that same side.
A front fender will catch more crud than a downtube fender, but downtube fenders are easier to mount.
explorer engine mounts removal
unbolt it from wheel tub inside, from radiator support under hood, and from cab firewall cowl under hood and also lower bottom rear corner in front of front cab mount on backside inside of fender, unbolt from inner fender shield in wheel tub opening arch also/
Remove the old mount & replace with the new.
How to replace tranmission mount
I believe it should be close to the battery
Follow the Youtube instructions.