Not hard at all. 6 bolts for the sway bar, and depending on how many links 8 bolts if it is a 4 link, figure 2 bolts per link. ues jack stands to hold the rear axel in place and do it one link at a time. The sway bar cones off in one piece so do that last.
In CT USA, a garage would charge 1 hour labor to replace the rear brake pads on that Mountaineer.
Front or rear?
You can pull the transmission or engine, witch ever you think would be the easyest for you. But you have to remove one of them to replace the rear main. It is a 1 piece seal and it drives over the back of the crankshaft.
Sensor is on the top front side of the rear differential, it's very simple, a single 3/8 inch bolt holdt it in. These sensors are a common problem. SHould take no more than 5 minutes to replace
You have to start by pulling out the transmission, this will give you access to the rear cover of the engine, and the rear crankshaft oil seal. You have to remove the rear engine cover once exposed, then you can pop out the old seal and press in the new one! And re-install transmission.
Simple once you find the hard-to-find special rear wiper blade. See sources and related links below for an installation video and for info on the special rear wiper blade.
not hard at all its simple
how to replace rear struts on a 2002 saturn L 300
as the rear is torsion it is not straight forward. the torsion bars have to be removed one side at a time, with the torsion bar out simply adjust hub the required amount and replace torsion bar. then do the other side. this can be hard as the bars can be difficult to remove. best left to professional should cost between £60-£100
how hard is it to replace a rear wheel bearing 1999 Honda crv. this crv does not have rear axle's in it. thank you
The rear are easy enough and the front drop links but for the front anti roll bar bushes you need to drop the front subframe, quite a big job.
Its easy once you get the special hard-to-find replacement rear wiper. See sources and related links below for wiper blade information and wiper blade installation videos.
Replace the bushings in the track bars that connect the rear axle to the vehicle.
2009 Toyota RAV4 rear wiper blade replacement procedure is extremely simple once you find the hard-to-get special rear wiper blade. See sources and related links below for installation videos and wiper information.
yes it will be hard and cost quite alot but well worth it!
When the rubber bushings have deteriated and are no longer doing their job.
Grab bars at the rear of the pillion passenger