Brakes and Tires
Saturn (car)
Chevy Tahoe
Chevy Blazer S-10

How how to find what sensor or problem causes the Anti-lock brake system to click all the time between 30 and 40 mph. no matter what surface you drive on?

161718

Top Answer
User Avatar
Wiki User
2006-02-27 13:31:53
2006-02-27 13:31:53

Are you sure it's the ABS and not a CV joint or perhaps a rust spot on the braking surfaces? Also perhaps a wheel bearing? It's the ABS, If I take the fuse out for the ABS it stops cliking. But them of course the Anit-Lock light stays on and the system is disabled.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The ABS (antilock brake) computer has detected a problem and set a code. You will need to have the codes read to know possible causes.The ABS (antilock brake) computer has detected a problem and set a code. You will need to have the codes read to know possible causes.

User Avatar

Problem with the Antilock Brake System, (ABS). The repair is best left to a professional.

User Avatar

A problem has been detected with the Antilock Brake System It could be a fuse , a sensor , or some other problem As long as the red " BRAKE " light in your dash is not on , you still have " normal " brakes

User Avatar

A problem with the Antilock Brake System has been detected . It could be a fuse , a sensor , or some other problem . As long as the red " BRAKE " light in your dash is not on you still have " normal " brakes

User Avatar

A problem has been detected with the Antilock Brake System . It could be a fuse , a sensor , or some other problem As long as the red " BRAKE " light in your dash is not lit up you still have "normal " brakes

User Avatar

It could be a fuse , a sensor , or some other problem with the Antilock Brake System ( as long as the red " BRAKE " light in your dash is not lit up you still have " normal " brakes )

User Avatar

The force of adhesion between water and glass molecules is greater than the force of cohesion between two water molecules.This causes the surface of the water to be curved. This curved surface is called a meniscus.

User Avatar

lieing, cheating and no communication between the parents.

User Avatar

umm the road, friction between your tires and the roads surface.

User Avatar

A rough surface; a lack of lubricants.

User Avatar

do you think there is really a problem.

User Avatar

2nd Gen. Ram Antilock brake lightIt is usually a sensor on top of the rear differential that causes the antilock and parking brake lights to remain on. There are some electical wires that plug into the front of it and it has a probe that goes into the differential. It also has a bracket that holds the brake lines in place. Removal of the spare tire gives ample room to gain access. Some times cleaning the probe fixes the problem, usual it is best to replace it compleatly.

User Avatar

Friction - between the surface of the ball, and the ground.

User Avatar

Both earth quakes and volcanoes are formed due to movement of tectonic plates underneath the earth's surface..

User Avatar

A surface wave is caused by an earthquake. When the earthquake causes primary, and secondary waves to interact, a surface wave is formed.

User Avatar

Actually, detergent causes the surface tension of water to decrease. Surface tension of water is caused by an intermolecular force called hydrogen bonding. The detergent interferes with the hydrogen bonding occurring between H2O molecules so, therefore, detergent decreases surface tension.

User Avatar

They are impact craters - the remains of collisions between an asteroid, comet, or meteorite and the Moon.

User Avatar

Could be many things but most commonly a wheel speed sensor and/or the wiring to it fails. A qualified garage can plug into the DTC connector and read the codes to help determine where the problem lies.

User Avatar

Gravity causes air to be denser near Earth's surface.

User Avatar

Adhesive forces is the attraction between a solid and liquid surface. The difference in strength is determined by the behavior of a liquid coming in contact with a solid.

User Avatar

The polarity of water causes the molecules to cling together, and forms surface tension.

User Avatar

The water vapourizes and in doing so forms a thin gaseous layer between the water drop and the hot surface, thus causing the droplet to bounce across the surface.

User Avatar

the extreme heat of the planet causes it to have a high rock content and so the surface looks rocky

User Avatar

the friction between the tire & the surface your driving on causes heat and which heats the tire + the air...


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.