0
How is the transmission shift cable removed on the 89 Acura Legend?
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Location of starter relay on a 93 acura legend automatic transmission?
Follow the + battery cable -jump the small terminal and the wire to the starter (Make sure in neutral) Starter should operate
Does a 1993 Acura Legend v6 3.2 have a speed-o-meter cable or is it electric If electric where is the sensor exactly?
== acura speed sensor }
Where is the starter on a 1991 Acura legend?
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
93 Acura Legend Speedometer is sticking?
1. If it's a cable type from the speedo to the gearbox, the inner cable may need lubrication
How to replace clutch 1989 Acura Legend?
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
How do you replace the thermostat on a 91 Acura Legend coupe?
The way to replace the thermostat on a 91 Acura Legend Coupe is to drain the radiator and remove the throttle and cable box. Remove the top of the radiator hose and the bolts. The thermostat will be inside.
Can a 1998 Acura Integra automatic transmission fit in a 1991 Acura Integra?
it will fit but you need to convert it to a cable clutch because the 98's are hydraulic
Will a 1994 Acura Integra gsr manual transmission fit a 1990 Acura Integra ls?
No, 90-93 was cable operated, 94-up was hydraulic.
Which relay is the starter relay on an automatic 1990 Acura Legend?
Postive battery cable should connect to the starter relay (solenoid)
Where is speed sensor in 90 Acura Legend?
It is mechanical, 2 piece cable, jack up car turn wheel left and look on drivers side and you will see cable.
How do you change a starter in a 89 Acura Legend?
To replace the starter in a 1989 Acura Legend you must first disconnect the negative cable on the battery. Disconnect the starter motor making sure you label each of the wires as they are removed. Remove the bolts which hold the starter to the engine and slide out the starter. Position the new starter to the engine. Torque the mounting bolts using 32 pounds of foot pressure per bolt. Connect the wires to the starter using the labels as a guide. Reconnect the battery cable and check the starter operation.
What causes the tachometer to stop working on a 1991 Acura Legend?
The tachometer cable may be faulty. The tachometer sensor, on the side of the engine might not be functioning properly.
