about 30/40 min
reddog: Can not find out how to get to the back of power outlet to unscrew it and replace it with a cigarette lighter.
open the very bottom door in the center panel. In the very back remove the two screws and pull out.
No, except that you insert the wires into the holes on the back of the outlet. The power in connects to the LINE side of the outlet and power out connects to the LOAD side of the outlet. This is clearly marked on the back of the outlet. This will not only protect the outlet with the GFCI installed but all outlets receiving their power from that GFCI. If you do not want to protect the outlets receiving power from the outlet then connect that outgoing wire to the LINE side also. But know that only the outlet with the GFCI will be protected and all other outlets will not be GFCI protected.
how do I get to the plug at the back of the power outlet/ ash tray 99 sable
the accesories fuse or the radio fuse The fuse for both the cigarette lighter in the dash or the fuse for the power outlet in the center console are blue 15 amp fuses, which are located behind the coin tray which doubles as a fuse box cover, on the back of which is printed the fuse layout.
The easiest way is to unplug it from the power outlet, wait 10 seconds, and plug it back in. Also, if the box lost connection with the TV, punch in channel 03 on your remote, then it will start working again.
A power outlet can be wired int a cigarette lighter. The wires will have to be cut, with the power off. Then the wires will need to be connected back together while adding the power outlet wires. The Connection will have to be a proper connection, preferably with crimp connectors.
It depends. It could be improperly installed. Outlets can be GFI protected by using a GFI rated breaker in the main panel box. Look for a breaker in the panel box that has a push to test button on it. Press the push to test button then plug something into the outlet to see if it still works. If the breaker turns off the power then it is GFI protected. To reset it flip the breaker to the fully of position then back to the on position.
I had the same problem and solved it: just unplug the power cable. Then while pressing the INPUT & VOL - buttons on the tv, plug the power cable back into the outlet (with your other hand) . When it powers up keep pressing the INPUT & VOL - after just a few seconds you will see
Where is the power coming from? Direct from the breaker panel or from another plug? Does that outlet have a wall switch? You pushed in the reset button on the new plug? You just have to back track and find the break in the line. Make sure the breaker is coming on.
Reset the fuses to turn back on the power.
Most likely causes are either the power plug is not in an outlet or the slot for the power plug in the back of the Wii is loose