Ford Ranger XL

How long is the brake line on a 1991 Ford Ranger?


Top Answer
User Avatar
Wiki User
2008-09-24 17:53:23
2008-09-24 17:53:23

There are more than one brake line(s) on the Ranger vehicles. The exact length of any given one is according to the Ranger model vehicle; eg: 2-Wheel drive, 4 Wheel drive, Regular car or extended cab etc. You can get a rough estimate regarding the length of just about any of the lines by looking under the vehicle and following them from their respective ENDING location to the MASTER BRAKE CYLINDER under the hood (driver's side).


Related Questions

What size is the steel brake line tubing on a 1994 Ford Ranger

Yes, there is a brake line diagram for the 1991 Ford Tempo. It is found in the cars repair or maintenance manual.

The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.

A 1991 Ford F1 50 break line diagram can be obtained from most Ford dealerships. The brake line diagram can also be found at most auto-parts stores.

A person can use a diagram as guide to make changes in the a car. The 1991 Ford F150 brake line diagram can be found in the cars maintenance manuals.

more than likely you have air in brake line and need to bleed brakes

Wikipedia has a great history of the ford ranger line.

Only your local auto parts store can give you the correct size and brake line for the type or model of vehicle you have.

The brake light fuse might keep tripping or going out on a 2001 Ford Ranger is there is a short in the line. The fault could also be with the part that tells the brake light to come on. This is located in the steering column. There is a brake light relay switch where the brake pedal is attached to the steering column.

how do I bleed the clutch system in a 2004 ford ranger

The brake fluid level might be low in the brake master cylinder in your engine compartment from a leak somewhere , or maybe you have air in the brake line(s) and the brake system needs to have the air blead out

What is a a/cl dv on a 1992 ford ranger xlt vacuum line

Motorcraft BXT - 59 ( is Fords " top of the line " battery for a 2002 Ford Ranger )

3/16 for a metal line. And rubber brake lines don't have sizes.

The front is on the handle bar and the rear is on or in line with the brake peddle.

yea. the bolts might not line up, but that's only 6 holes you have to drill out

The brake lines on a Ford Escape are replaced by removing the wheel, unscrewing the brake line at the wheel cylinder, and then at the distribution valve. New lines can then be set into place and screwed into the appropriate connector.

replace the brake line and then bleed the brakes

A brake line diagram for a 1995 Ford F150 can be found in a Hayes Repair Manual for that make and year of Ford. This manual is available for around $25 at most automobile parts stores.

where can i find a vacuum line diagram for 1989 ford 2.9 liter engine

you dont. get a new one. those lines are under significant pressure and should not have patch jobs. if you really need to you can go the wrecking yeard and pull one off another another ranger. i would highly advise against repairing the line.

If you are talking about the line it compresses in.

wheel is out of line so go rotate them B******

You will need the Ford Hydraulic Clutch Quick Disconnect Tool. ( one of Fords websites ) shows Motorcraft BXT56 ( top of the line ) or BXL56A , as the Motorcraft battery choices for the 1984 Ford Ranger

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.