Its not neccissarry, but you can if you want to, as long as the belt looks and is in good shape then you dont need to.
It doesn't matter to the strut where the spring pressure is and for how long.
The wheel bearings are sealed and should last a long time. If you think they are bad you would have to replace the bearings they cannot be repacked.
about 6 hours
Labor time is about 5 hours.
About 7-8 hours.
pull the coils out should be an 8mm bolt holding them in its an coil over system once coil is out get a long extension and you can remove them
I will take about 1hr and will cost $300.00
It will take approximately 1.5 hours to replace the power steering pump in your 2000 Dodge Durango. The exact amount of time will depend upon the person that is doing the repair.
5 hours give or take a little.
i got whole spindle on in less than hour and half
Flat rate labor time is about 5 hours.
About 1 hour
In a 2005 Durango, aprox 1 1/2 hours.
As long as it is in the normal range (not at either extreme) you should be OK
I would think so as long as it has the same number of lugs, the pattern should be the same.
A dodge ram can last up to 200,000 miles. There are many on the road with that many miles still.
I got quoted an hour for mine
You should replace your printer toner when your computer is telling you that it is running low. If you wait too long it will start to miss spots on your prints.
Chrysler V6, six to eight hours. Mercedes/Dodge Sprinter, two to three hours.
no. it has a chain not belt. it should last as long as the car.
it depends on the person. for me as long as their are no other problems along the way and nothing has to be machined about 5 to 6 hours.
Strut mount and suspension strut mount are very crucial parts of the vehicle. These are the aftermarket auto parts manufactured to replace the damaged original parts in any vehicle. Sujan Industries is the leading manufacturer and supplier of these two crucial aftermarket auto components in India and abroad. Here, all the products are long-lasting, help to extend the longevity of the auto car and also provide driver and passenger satisfaction. Strut mount is used to attach the suspension strut to the vehicle. It aids in minimizing vibration and tire noise. Its front part helps to link to the strut assembly to the car and the rear part is attached to the strut. In the middle, a rubber-like cushioning material is used. So when the car comes over any bumps during motion, the agitation pushes and pulls at the mount. The suspension strut mount absorbs the vibration and noise and the entire strut helps to minimize the noise and vibrations from spreading out. It is located at the top of the suspension strut assembly. Its main function is to mitigate vibrations and shocks. At Sujan Industries, all the auto parts are of premium quality, customized and affordable. So for any related requirements, get in touch.