0
How many ball joints does a Nissan 2000 pathfinder LE 4wd have?
Wiki User
∙ 13y ago
Two. One on each side in the front. There are only lower ball joints on this vehicle. There are no upper ball joints - there are struts instead.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you replace ball joints on 1995 Nissan truck?
how to replace lower ball joints on 1995 4 wheel drive Nissan truck
How do you lube ball joints on a 2001 Nissan Xterra 4wheel drive?
If they are the original ball joints they can't be lubed.
How to tell ball joints need replacing on 2000 gmc envoy?
how do you replace ball joints on a 2000 envoy
How much should a ball joint replacement cost for a 2002 Nissan Pathfinder?
40
How many ball joints on a 2000 Ford Mustang?
There is not a good and clear indication on how many ball joints are on a 2000 Ford Mustang. After searching around, there are conclusions that there are at least two ball joints on the Mustang.
Does a 2000 Lincoln ls have upper ball joints?
On a 2000 Lincoln LS : The FRONT suspension is a strut type suspension , so there are ( NO ) upper ball joints
Where are the grease fitting on a 2000 dodge ram 1500?
Check tie rods, ball joints, trac bar, and u-joints.Check tie rods, ball joints, trac bar, and u-joints.
How do you change upper ball joints on a 2000 Yamaha kodiak?
I think 2000-2002 are welded in.
How to replace 2000 Ford F-150 lower ball joints?
You need to have a "Ball joint press".
Does a 2000 Lincoln ls have rear ball joints?
I was looking at one of Fords websites and for a 2000 Lincoln LS REAR suspension , as far as I can tell from the drawings , there are ball joints on the top on what they call the " trailing arms "
What would cause a knocking or clunking noise of my 99 Nissan Altima after the sturts have been replaced?
It is common to have a knocking or clunking noise of a 99 Nissan Altima, even after the struts have been replaced. This may be due to worn ball joints. It is best to replace the ball joints, too.
How do you replace lower ball joints on a 2000 S10 blazer?
first you take it in then pay them to do them for you!!!!!!!!!!
