Asked in Fuel PumpsWater PumpsDodge Intrepid1995-2005 Chevy Cavaliers
1995-2005 Chevy Cavaliers
How many bolts do you need to mount a water pump on a 97 intrepid 3.5 6 cylinder engine?
Asked in Chevy S-10
What are the torque specs for a 1996 Chevy s10 4.3 liter?
Asked in Chevy Astro, DIY Projects
How do you replace 1991 astro van motor mount?
Asked in Chrysler LeBaron
Where is the starter located on a 1993 Chrysler LeBaron?
Four cylinder, it is on the rear of the engine below the exhaust manifold. Six cylinder, it is on the front of the engine, behind the motor mount bracket. Four cylinder, it is on the rear of the engine below the exhaust manifold. Six cylinder, it is on the front of the engine, behind the motor mount bracket.
What is the torque specs for a 99 Chevy s-10 2.2 head bolt?
The torque specs for cylinder head bolts in the S10 are Long bolts 46 foot lbs, short bolts 43, engine mount to engine bolts 39, engine mount through bolts 38, engine mount bracket to frame,33, exhaust manifold nuts 115 in lbs, flywheel driveplate to crankshaft, 55, Intake manifold to cylinder head nuts/bolts up through 1998 24, 99 up 17, lifter guide retainer to block studs 97 in lb, oil pan bolts 89 in lbs, oil pump to block bolt 32, rocker arm studs 37, rocker arm nuts (bolts on 99 up) 19-22, timing chain cover bolts 97 in lbs, valve cover bolts 89 in lbs
Saturn sl1 where's the upper motor mount located How do you replace it?
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
How do you replace the motor mounts on a 1986 F-150 6 cylinder 4.9 engine?
Use a floor jack and some wood blocks to support the engine. Put the wood under the front pulley and on the jack. Loosen the nuts & bolts, and lift the engine slowly until the mount is loose. Then remove the nuts & bolts for the mount and remove the mount. You may have to lift the engine up a little more to clear everything. Then do just the opposite order to put it in.
Where are the engine mounts 1997 crown vic?
Asked in Ford Focus
How do you replace transmission mount Ford Focus?
Where is the starter motor located at on a 2001 Dodge Intrepid with a 2.7 L engine?
Asked in Jeep Cherokee Laredo, Chevy 350
How many bolts to mount transmission to a Chevy 350?
Asked in Dodge Caravan, VW Cabriolet, VW Passat
Are the bolts for the starter located at top or bottom on a '93 Volkswagen Passat?
Asked in Toyota 4Runner
How do you remove the starter from a 1998 Toyota 4runner 4 cylinder?
Asked in Dodge Grand Caravan
Where are the top engine mouting bolts on a Dodge Grand Caravan 2003 3.3L V6?
Asked in Thermostats, Toyota Solara
Where is the location of the thermostat on a 2000 Toyota solara?
Asked in Chevy Celebrity, Chevy Silverado
Where are the motor mounts located on a 87 Chevy Celebrity?
There is one mount in the center of the engine below the vibration damper. There is the torsion strut mounted to the top of the radiator support then to the top of the engine. If your car has the 205L 4 cylinder engine there is another mount on the transaxle in line with the center of the engine. If your car has the 2.8L 6 cylinder engine there is a mount on either side of the transaxle.
Asked in Cars & Vehicles, Dodge Intrepid
Where is the oil pressure switch located at for a 1999 Dodge Intrepid 2.7?
Asked in Chrysler New Yorker
Where is the starter located on 1990 Chrysler new yorker?