0
How many oxygen sensors on 91 chev silverado pickup 350 motor?
Wiki User
∙ 12y ago
It has 2
^wrong tbi motors only have 1 and its on the drivers side.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many oxygen sensors on 1988 Chevy silverado have 350 motor?
It has 1
Where are all the oxygen sensors in a 1991 Isuzu pickup?
If you have a 2.3 or a 2.6 motor, there should just be one oxygen sensor. It will be located on the exhaust manifold. On the driver's side of the motor you should see it down by the firewall. It will have a single wire coming from it.
Where is the blower motor on a 1990 Chevy silverado pickup?
It is under the dash where the passagers feet go.
What size motor is in a 1996 Chevy Silverado 1500 Pickup?
The Chevy SBC 5.7L 350cid V8 was the standard
95 Chevy silverado 1500 pickup what size motor is that?
305(5.0) or 350(5.7) most likely a 350
Does a 1999 Chevy silverado pickup have reistors for the heater speeds control?
Yes, located in the blower motor resistor pack. Follow the wires backward from the blower motor to find it.
How many heated oxygen sensors does a 1995 ford explorer 4.0 motor have?
( 2 sensors ) - # 6 fuse - 15 amp - HEGO sensors ( in the fuse panel in the drivers end of the dash )
How many oxygen sensors does a 2003 Honda Accord 2.4 liter have?
This model accord has two oxygen sensors, when in the front in the motor and one under the passenger seat and both can be pretty costly about 100 apiece..
Where are the oxygen sensors located on a ford probe 97 GT and how many are?
There are a total of four Oxygen Sensors: one in each exhaust manifold near the motor, and one on either side (upstream & downstream) of the catalytic converter.
Is a oxygen sensors a part of the motor?
Oxygen sensor are part of air / fuel measuring device and it's located on exhaust system before and after cat-converter .
Can you clean oxygen sensors?
Jim rice from sinclareville ny say soak it in used motor oil then stick it back in..
How do you replace drivers side window motor in a 02 silverado pickup?
Remove the door panel and unclipped the three plastic retaining tabs that hold the window motor in place disconnect wire connector and it's out
