answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-07-20 18:48:51

I have a 2001 2.7 L Intrepid and it takes 4.5 quarts

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

User Avatar
Anonymous
Answered 2020-04-17 12:40:15

WHY IS IT SO HARD TO FIND A ANSWER TO HOW MANY QUARTS OF I NEED TO CHANGE THE OIL IN MY 2001 INTREPID

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The thermostat on a 2.7L Dodge Intrepid is under the housing where the lower radiator hose attaches to the engine.



The only fuel filter on a 2000 Dodge Intrepid is part of the pump module in the fuel tank.


No, it will not, design is much too different to make it feasable. For a 2000 intrepid you must use a 1998-2001 engine. Check out dodgeintrepid.net for a ton of info on these cars.




Check Engine code of P0404 (EGR)


The engine computer is also the voltage regulator.


if you have zero transmission fluid it takes 9.5 quarts


I need detailed information on how to replace a starter for a 2000 dodge intrepid


The 2000 Dodge Intrepid with the 2.7L 6-cylinder came in two engines with code 'U' and 'EER.' Both engines specify a engine oil fill of 5-quarts, including the filter. 5 and 10W30 can be used in this engine. 0W30 can be used in arctic and severe winter conditions, in addition to all-season use.


The AC low pressure port on a 2000 Dodge Intrepid is located on the side of the AC accumulator. It is positioned in the left, rear area of the engine compartment.


Under the housing where the lower radiator hose hooks to the engine.



on the bottom of the engine.... some people shouldn't own a vehicle


For the engine oil - at the bottom of the oil pan.


You pour it into the plastic bottle on the left side of the engine compartment.


http://wiki.answers.com/Q/How_do_you_remove_the_engine_cooling_fan_assembly_from_a_2000_dodge_intrepid"


It is under the housing that the lower radiator hose hooks to on the engine.


Driver side of the engine, just below the exhaust manifold.


yup i have a set off a 2000 on my 97 they fit perfect


Yes you can but, you have to use the flywheel off of the 2002 engine on the 1998 engine other than that you just have to hook up the wiring harness off the 2002 onto the 98.


go to dodge intrepid.net...everything you need is there



The vehicle identification number on a 2000 Dodge Intrepid motor is found etched into the block at the oil sump plate. This oil sump plate sits at a 45 degree angle to the block.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.