It takes about 4.5 quarts if you're changing the filter, which is located on the BACK side of the engine. Drain plug is on the bottom of the engine on the oil pan.
I recommend only Honda genuine Z1. About 3.5 quarts on a drain and fill
It is on the rear of the engine block above the drain plug.
No
There is no user serviceable filter on Honda Accord. During a rebuild, there is a screen that is replaced. Use genuine Honda Z1 fluid, wipe off the magnetic part of the drain plug well, and check the level warmed up within a few minutes of turning off the engine on level ground. Apx 3.5 quarts
Around 4.5 quarts with oil/filter change. Park on level surface. Drain oil and change filter. Add 4 quarts, start the engine and run for 30 seconds. Shut off and wait 30 minutes. Check level and add as necessary. Do not overfill.
4 quarts Closer to about 4.4 quarts if you let enough oil drain. Refer to the manual located (hopefully) in your glovebox.
There is no trans filter on the Accord. You drain the fluid just like you would your motor oil. Only about 1/3 of the total capacity will drain. Be sure to add only the amount that was drained and use Honda fluid only.
where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006
There is no drain plug.
The 1999 Honda Accord air conditioning drain to can be located on the bottom of the air conditioner compressor. The drain to allows condensation to drain on the ground below the engine.
The transmission drain plug is on the bottom of the tranny, underneath. You will need to lift the car up. there is no trans filter.
The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.