It has 3 holding it. The 1 your probley looking for is behind the small panel that is snapped in behind the door handle on the inside. pop the cover out with a small screewdriver and then remove the screew and then lift the door panel stright up and then pull off.
Removing a 1991 Chevrolet Silverado door panel is pretty simple. All you will need to do is to remove the screws holding the door panel in place.
take door panel off should be screwed to door remove screws take speaker out unhook wires
Remove the rear door panel.
You will need to remove the screws in the door. They are located in the door handle, the door latch and at the very bottom of the panel. Once you remove the three screws pull the panel and it will pop out.
There are three places where the door panel has screws that need to be removed. You also need to remove the window crank and any other hardware that is external to the panel.
there should be a screw where the door handle is and maybe on the corners of the door panel. undo any screws and take off any handles then pop off the panel with a flathead screwdriver.
I dont know. Ive never done it!
YES it will.
For a 2000 Chevy Silverado Ext Cab 4 dr 4x4 Z71 Front 6.5/6.75 inch speaker remove door panel and then install new speaker reattach panel. Rear 4x6 inch speaker remove rear door panel and install new speaker reattach panel.
The 2000 Chevy Astro sliding door panel is held in place by two retaining screws and eight retaining clips. Remove the retaining screws and pry outward on the retaining clips.
on my 2000 s-type, the drivers door panel is held on by 2 screws located in the interior door pull under the small rubber mat. remove those screws and pry the panel off. pry the panel off from each snap on position, being careful not to damage the snap mounts.
door latch diagram for 2000 Chevrolet silverado