How many turns does the air fuel ratio screw take on 1994 polaris 4x4 300?
ADJUSTMENT - BANDS FRONT BAND The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers. Raise vehicle. Loosen band adjusting screw locknut. Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw threads if necessary. Tighten band adjusting screw to 8 N�m (72 in. lbs.) torque with Inch Pound Torque Wrench C-3380-A, a…
When you turn off your 1994 Nissan altima the brake lights are still on how can you fix this problem?
Most imports have a rubber plug in the brake pedal arm.It hits the brake light switch to turn it of.Look in the floorboard for pieces of rubber.If this piece came out,tou can put a flat screw in its place.If you use a screw you will need to un-screw the brake light switch 1-2 turns to adjust the switch so the brakes dont lock-up.
Crawl under the vehicle and write down the number you find on the rear axle housing. Any GM dealer can provide the ratio with this number. You can also do it the old fashion way. Jack up the car, put the transmission in neutral, rotate the wheel 360 degrees and count the number of times the drive shaft turns.