answersLogoWhite

0


Best Answer

Unless it has been retrofitted the '89 I believe still took freon. If it has been completely empitied out it will take a couple of those cans from Walmart. If the system has been opened up to replace a component, you will have to use a vacuum pump to remove all air and moisture from the system. Oil will also have to be added, but you can get all that in one can.

User Avatar

Wiki User

โˆ™ 2009-03-12 03:50:10
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How much R134 goes into a 1989 Ford F150 with a 4.9 liter engine?
Write your answer...
Submit
Related questions

Will the 4.6 liter engine from a 1995 Ford Thunderbird fit a 1998 Ford F150 that has a bad 4.6 liter engine?

yes


Engine diagram for ford f150 5.4 LITER ENGINE?

a/c compresser


How do you change a water pump on ford F150 1989 5.0 liter?

The water pump on a 1989 Ford F150 5.0 liter is changed by removing the engine accessories, disconnecting the radiator hoses, and removing the retaining bolts. The pump is then pulled from the block, a new gasket put in place, and the new pump installed.


Does Ford make a 5.4 f150 v6 engine?

No , the 5.4 liter is a ( V8 ) engine in the Ford F-150


What size engine is the 4.6l in the 98 ford f150?

281 cubic inches for the Ford 4.6 liter V8 engine


Where is the oil sending unit on a 1997 Ford F150 6.2 liter engine?

there is no 6.2 engine


Will a 4.2 liter Ford Freestar engine work in a F150?

No. The F150 installation is longitudinal and the Freestar is not. That makes the manifolding incompatible.


What is the spark plug gap for a 1989 Ford Mustang 2.3 liter engine?

( .044 inch ) for the 2.3 liter four cylinder engine in a 1989 Ford Mustang ( according to one of the Ford websites )


Where can i find a vacuum line diagram for 1989 ford ranger 2.9 liter?

where can i find a vacuum line diagram for 1989 ford 2.9 liter engine


What is the engine oil capacity for a 1997 Ford F150 4.6 liter V8?

about 5 qts


What size engine is in the 1989 Ford Bronco II?

A 1989 Ford Bronco II has a ( 2.9 liter / 177 cubic inch V6 engine )


Where are the coils located on a ford F150 5.4 liter engine?

on top of the spark plugs in the intake manifold.


What is the oil filter of a Ford f150 4x4 5.4 liter engine?

Type your answer here... Fram PH2


What engine can fit into a 1989 Tempo?

You can fit the remanufactured 18 liter Ford engine in the 1989 Tempo. You can also choose the 3.0 liter SHO engine that was found in the Escort at about the same time.Ê


Where is Egr valve location 2004 ford f150 5.4l?

The EGR valve, on a 2004 Ford F150 5.4 liter engine, is located on the top of the engine near the back. The valve is difficult to identify without prior mechanical knowledge.


Did ford make an f150 step side in 1982?

Yes they did. I had one. It had a 4.9 liter engine and manual transmission.


Where is the oxygen sensors on a 2000 ford f150 4x4 truck 5.4 liter engine?

There usually on the exhaust header


Where is the spout connector on 1990 ford f150 5.0 liter?

I believe it should be close to the distributor at the front of the engine


Where is the oil sending unit located on a 1997 Ford F150 4.2 liter?

Front drivers side of engine.


What is the firing order for a 2002 Ford F150?

We need to know which engine you have to answer this question.


What is ignition timing 1989 ford 7.5 liter?

10 degrees BTDC ( unless engine compartment decal shows different ) for the 7.5 liter ( 460 cubic inch ) V8 engine in a 1989 Ford truck


Where is the fuel pump for ford f150 supercrew 5.4 liter engine?

probably in the gas tank. call a ford dealership and ask to talk to a mechanic.


Which side of the engine is bank 1 on 2005 Ford F150 4.6 liter for cam shaft sensor?

bank 1 is the passenger side of the engine


Where is bank 2 on a 2005 f150 4.2 engine?

Bank 2 is the drivers side of your 4.2 liter V6 engine in a 2005 Ford F-150


What is the Engine Oil Capacity 2001 Ford 5.4 Liter V8 in the F150?

owners manual in glove box should say