Around 2700-2900 lbs
Dodge does not use inertia/reset switches.
A 1990 Daytona 3.0 came with a 4 speed automatic or a 5 speed manual.
Dodge does not use inertia/reset switches.Dodge does not use inertia/reset switches.
i think it was a 3speed and optional 4speed
On your 1991 DODGE DAYTONA, the FLASHER is: FRONT SEATING AREA, DRIVER SIDE, UNDER DASH, MOUNTED ABOVE KICK PANEL Go to Autozone.com under component location for help with this stuff.
There were a total of around 38,000 Dodge Daytonas built in 1990 - unfortunately there's no specific breakdown of what different trim and models were sold.
No.
Most likely a weak turn signal flasher Could also be a bad switch
It is the middle relay (of the 3) on the drivers side fender well (In front of the shock tower)
What size gas tank does the 1990 Honda Civic Hatchback have?" i have a 1990 civic and i have never been able to put in more than 10 gal.
The pick up coil for this engine should be right underneath the rotor inside the distributor cap. Unscrew the two screws holding the cap on, remove the rotor below it, then you should be able to lift out the pick up coil. I don't recall anything additional used to attach it, just the distributor cap screws.
I have a 1991 - 50th anniversary coin. Yes, I have a 1990 daytona bike week 999 silver coin