You will need three more bits of information.
1. How high are the walls.
2. What is the length of the room.
3. What is the width of the room.
Let me give you an example.
Height of walls = 8 ft.
Length = 50 ft.
Width = 20 ft.
Each piece of drywall is 8' X 4'.
In this case, the height of the walls exactly matches the height of the drywall; so you won't have to make any cuts in that dimension.
Figure out how many sheets you will need for the 50' walls.
50' / 4' = 12 1/2 pieces of drywall.
There are two of those 50' walls; so multiply by 2.
12 1/2 X 2 = 25 pieces.
Now for the short walls.
20' / 4' = 5 pieces of drywall.
Again, there are 2 short walls, so multiply by 2.
5 X 2 = 10 pieces of dry wall.
Add what you need for the long walls and short walls.
25 + 10 = 35 drywall sheets.
Answer: 35 drywall sheets.
Thirteen sheets for walls, nine for ceiling.
If the ceiling is 8 ft high as is normal, then it will take approximately 40 standard sheets.
1,000 dollars
you will need probley 1000 to make it a good one props 2000 thats what i think
That will take 27 sheets.
To the nearest board you'll need 21 boards. However, this is assuming complete flat surfaces, no cutting and waste
You put post protectors in the drywall, and don't do it at the end of the drywall.
Each sheet covers 48 square feet. Divide 1500 by 48 gives you 31.25 sheets of drywall.
Forget about 'average' -Give us square feet.
You should never anchor a wall arm like this into just drywall. It is very dangerous. You will need to find a wall stud under the drywall to anchor this into.
No, you don't use drywall anchors if you can use a stud.
You need all the Halo 3 Achievmentswhich is 1000/1000 Gamerscore for Halo Katana.
1000
i dont know thats why i asked?
When a large section of your ceiling's drywall is saggy, you need more than a spot repair. Sometimes the problem is so severe that removing an entire 4 X 8-foot drywall panel is the best solution. A few professional hints can make the job of drywall patch repair go more smoothly. Attic insulation should be cleared out Dispose of the old drywall Affix the nails with nail strips Drywall Panels Need to be Screwed In It's time to tape and mud