anywhere between 20-60 depending on material
What are the head bolt torque specs for a mazda mx3 1600
You pull the head off and change the head gasket. There is no treatment for a blow gasket, exept changing it. Its a pretty huge job I would suggest getting it at the garage and get a quote.
The white smoke means coolant being burned. So the chances that its a head gasket problem are pretty high.
A leaking gasket, a leaking filter, or a leaking drain plug....
mx-3.com check there
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
This is done the same as the 1995 Mazda MX6. The answer is posted.
waste of time
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
don't accelerate as much or change up a gear
By regulating the fuel pressure