Cheap... A couple hundred bucks if you do it yourself. How long do you need this thing to last? If the clutch is just worn, and you have not driven it much w/ the worn clutch, you might be able to get away with replacing just the clutch disk and throwout bearing while leaving the pressure plate and flywheel for the next owner. If the clutch is blown, meaning the throwout bearing seized, the springs on the pressure plate are toast or you drove it with a slipping clutch for too long, the cost will be more, as the pressure plate adds $100 and machining the flywheel is another 30 - 50$.
yes check out the Chilton auto repair guide
A wiring diagram of a 1989 Bronco 11 fuel pump can be purchased from most auto parts stores. It can also be found in do-it-yourself repair books for a 1989 Bronco 11.
bleeding and Transmission do not go in the same sentance...lol If you have a hydraulic clutch, that is another story :)
list of fuses for 1989 bronco 2
It is important to bleed a clutch master and slave cylinder to make sure all of the air is out of the lines. For a 1989 Chevy you would need to know model you had, and then find the repair manual for that specific vehicle.
it shold
yes
how to remove oil pan from 1989 bronco 2
8.8
A 1989 Ford Bronco II has a ( 2.9 liter / 177 cubic inch V6 engine )
Its an A4LD.
Yes. The Bronco body style didn't change again until after 1989.