enough...i joke...i don know
About 900 hp
If it is a stroke emty some of the gas and add some more gas
They are all 2 stroke 200cc motors. Unless you add a big bore kit then its 248cc
if there isn't one in between the fuel line from the gas tank to the carb then no but you can easily add one
no...yamaha blasters are oil injected when stock, tho allot of people that race add on an aftermarket oil injection block off kit that allows them to pre mix there own fuel.
for every 9.2 litters of gas add 16 ml of 2 stroke premix oil wich is 32-1
I don't have a Yamaha blaster.... but I did a little search and found out that it is a two cycle engine. I'm sure that you realize that in a two cycle engine, you lubricate the engine through the oil that is added to the gas, and not through a traditional oil reservoir system. As far as what kind of oil you can add to the fuel to create the proper mix.... their are specially created oils for two cycle use. I know of one Yamaha two cycle oil that was used in a Yamaha scooter I had... it was called "yamalube" ... good luck!
Where do you add water in the Yamaha grizzly 660?
Easy way to check if the level is correct is to remove filler cap take your pinky finger stick it in the oil filler hole to the first knuckle. remove finger the very tip of your finger should have oil on it. If not add alittle.
its curb weight is 495 lbs depending on add onc
its curb weight is 495 lbs depending on add onc
Remove the crankcase breather cap up in front of the engine and add motor oil down the tube.