How much should it cost to have a v-belt changed on a 2001 BMW 325i?

is in hard to replace a thermostat on a 2001 bmw 325i

It should last the life of the engine.

How often need to change the fuel filter for a 2001 BMW 325i?"

Timing chain - all E36 and E46 models use a timing chain. BMW timing chains are engineered to last the life of the engine.

The E46 325i was produced from the years 1999 to 2006 in the United States. The main relay in a 2001 E46 325i model is situated behind the glove compartment.

A 2001 BMW 325i has two coolant temperature sensors. They constantly monitor the temperature and adjust flow as needed.

How do you clean out bottom drains of quarter panel on a 2001 325i?Read more: http://wiki.answers.com/How_do_you_clean_out_bottom_dains_of_quarter_panel_on_a_2001_325i#ixzz1YzPcBxqW

An e46(2001-2006) 325i/xi has a 16 gallon gas tank

4.58 metres or 178 inches

When it is no longer maintained by the owner.

no it is an interference. good luck

The main relay switch is located near the fuse box, on your 2001 BMW E46 325i. The relay and the fuse box are located under the hood of the engine compartment.

I just changed a turn signal bulb in my 2001 330xi. I found the answer on Wiki. Look for the question "How do you replace the front turn signal bulb located on a 2000 BMW 323?" Same design. And, surprisingly, very easy to change. Should be similar to this: http://m3.madrussian.net/diy_front_turnsignal.shtml

It is down on the kick panel in front of the drivers door.

also, are any special tools required?

Are car BMW Type 325 Date Make 2001 has a alarm system by the manufacturer

I have a 2006 325i and i have jumped it.

remove the hex bolt on the rotor and give it a smack with a mallet

on the right under where you turn headlights on,

It is on the right side (looking at the car from the back) of the oil pan.

Grade 93+, your manual should have this info.

I just recently changed the plugs on my 2001 325ci coupe.......yes i know different car, but the idea is the same. Here is a diy for a 330ci, its going to be almost identical on your car http://www.bmw330ci.net/maintenance/valve.php

Any dealership should take it. Check blue book & you can sell it to Car Max & use proceeds to buy anywhere which is even better.

It should fit, the engine size are the same. I think its still based off the M52 Inline-6, just the displacement is different (2.5L to 3.0L)

there shout be a button by your right foot near the hood release...